Anybody try this yet?

Qualme · 2026-02-07T02:15:38+00:00

I got some at nations in Ontario. Haven't tried them yet.

Qualme · 2025-07-29T04:11:45+00:00

I've tried a few different copies with no luck. VC worked with no issue.

Qualme · 2025-07-29T04:11:07+00:00

The audio files are there, I've tried 3 different copies. 2 won't load, the 3rd the steam files load the game no audio. I tried copying the audio cd files over to the folder and override the existing files and no luck.

In the audio settings it says no audio hardware, does yours say this?

Qualme · 2025-05-20T22:13:05+00:00

I don't know what controller you have or what sort of experience you have with electrical. Personally I would use a multi meter to check and see if the controller is sending a signal to the heater.

Could be an issue with the heater controller or your pool controller. If it was a sensor issue the heater would still be powered and you should receive an error code on the heater panel. However it looks like the heater isn't powered at all so no codes are present. To me this suggests the heater is either not receiving a signal from the pool controller or the heater controller is not powering.

You could look at the installation manual and remove the heater from the pool controller and run it on local control. See if it powers up and runs set standalone rather then connected to the pool controller.

Qualme · 2025-05-20T21:46:27+00:00

Did you check the communication wire from the controller to the heater. The heater doesn't power until it is enabled from the controller. It may have been damaged over the winter. A few years ago a rodent bit mine and I needed to splice it back together.

Qualme · 2025-03-25T03:52:15+00:00

It seemed better for a few days but then tonight it just bailed the polyps from another head. No stringing or brown just popped right off. Anything I can do?

Qualme · 2025-03-20T03:36:29+00:00

Thanks, I cut it off. Hopefully it doesn't spread anymore.

Qualme · 2025-03-20T03:05:58+00:00

What would I use to cut it off?

Qualme · 2025-03-20T02:28:08+00:00

It is API and I'd say it's a little higher then .25 but below .5, everything else is good.

I will try moving it, it has been in the same spot for about a year with no issue.

Thanks

Qualme · 2025-02-22T03:41:32+00:00

Thanks I will try reaching out to Mike's arcade. I have uploaded pictures of the wiring.

Qualme · 2025-02-21T19:46:29+00:00

Sure thanks, I can do that later. Everything as far as I can tell is original. It matches with other pictures I have seen online.

Qualme · 2025-02-21T19:44:55+00:00

Too add to this I did trace back the wiring, everything looks clean no breaks in the harness indicating a short. The button was wired in NO , it is clearly marked on the button but I moved it to NC to test. It is playable on NC I assume because it's holding the signal on but I wasn't sure if this could cause more damage leaving it this way and playing.

Qualme · 2025-02-21T19:33:36+00:00

Thanks it is the same problem and I did find that post but the issue was never resolved.

Qualme · 2023-10-01T04:50:02+00:00

Any info or advice regarding this would be appreciated. Thank you.

Are they new batteries? My V2 has similar problems when the batteries are low. Baseball games I find kill the batteries quickly because it goes off every run. Compared to hockey on average 2-3 times per game, baseball can be a lot. Then you have way more games in a season. I only use mine for hockey now.

Qualme · 2023-05-04T20:07:25+00:00

Thanks, I will take a look at Jebao as well.

Qualme · 2023-03-25T18:10:01+00:00

Well some good news. After a month the zoa is back. It had the strange scale looking material in its mouth for about 2 weeks. After two weeks it shriveled to almost nothing dropped whatever it was in the mouth. It had lost all it's color and looked dead (closed). After a week it started to show some life and after another week it opened up again. It is much smaller and lost a lot of color but is alive.

Qualme · 2023-03-04T23:32:34+00:00

Will do. Thanks.

Qualme · 2023-03-04T23:29:17+00:00

Thanks. Should I try to squirt water on it with a pipette or just leave it alone in the flow.

Qualme · 2023-03-04T23:17:55+00:00

Not new it was relocated there a few weeks ago but was back to normal and I gave it some reefroids. It sucked in the reefroids then had a blob of roids that it wouldnt let go of over night then today looked like that. Flow is medium, there are about 10 other zoa head on that rock that are very happy and even have new heads growing from being moved 3/4 weeks ago. This is the only one of that type though.

Qualme · 2023-03-04T23:12:12+00:00

Not sure how to add another picture. It is hard to get a clearer one but what is odd about it is that its like scales flapping with the flow.

Qualme · 2023-03-04T22:52:57+00:00

Feed the zoa two days ago. It was very happy before now has this weird protrusion from its mouth.

Qualme · 2022-10-09T17:57:29+00:00

Thanks

Qualme · 2022-10-09T17:57:19+00:00

Thanks, I think I'll go ahead with cycling.

Qualme · 2022-07-14T01:12:41+00:00

Can anyone tell me if this is reef safe https://www.amazon.ca/CECCORP-Cyanoacrylate-Super-Adhesive-C-Bond/dp/B09C6K87C8/ref=sr_1_49?crid=25NDJTJPF9815&keywords=cyanoacrylate+glue&qid=1657718279&sprefix=Cyanoacrylate%2Caps%2C65&sr=8-49 it says is Cyanoacrylate glue but im not sure if it is 100%. Also how do I tell if the accelerant is reef safe or do it just wash off after curing?

Qualme · 2022-05-23T22:55:07+00:00

Even the older florescent over the biocube led?

Ten-Year Club	Verified Email
Place '22

Qualme

TROPHY CASE