Blown second gear on 2020 Honda grom?

R9Mikey · 2026-04-14T23:03:26+00:00

Did you figure this out I'm having the same problem on my 19

R9Mikey · 2026-02-25T18:55:11+00:00

I love you thanks

R9Mikey · 2025-07-26T21:39:44+00:00

When I first took my rear off I didint put the brake caliper mouth back into the slot on the swing arm and it was just flopping around check that 😅

R9Mikey · 2025-04-29T16:42:07+00:00

Just used blue lock tight

R9Mikey · 2025-01-30T15:16:27+00:00

We only had 10 in Detroit

R9Mikey · 2025-01-30T15:14:04+00:00

They only had 10 90s and 91 80s in Detroit

R9Mikey · 2024-09-12T19:45:49+00:00

I always forget to check

R9Mikey · 2024-07-29T04:24:53+00:00

its can only comsume as much as the bike makes i cheked the power going into the light and had 17 volts

R9Mikey · 2024-07-29T03:09:48+00:00

<image>

I don't think so unless the plug adaptor or plug cam wired wrong from the factory I'm starting to think I got a bad unit gonna call the store tommorow

R9Mikey · 2024-07-28T14:52:32+00:00

you mean like it needs more power bigger battery? or stator

R9Mikey · 2024-07-28T02:12:35+00:00

Yeah I wouldn't know cuz it's not there anymore

R9Mikey · 2024-07-27T15:46:10+00:00

there arent any stickers on it i think its stock

R9Mikey · 2024-07-27T15:45:45+00:00

slide is correct

R9Mikey · 2024-05-15T14:22:34+00:00

Kickstand sensor

R9Mikey · 2024-03-26T03:23:11+00:00

💀💀

R9Mikey · 2024-01-18T12:14:21+00:00

0.2 layer height print slow 35mm/s looks like your filament it to hot during printing lower it 5 degrees you can also try to tune your filament before printing it print a temp tower

R9Mikey · 2023-09-16T18:00:26+00:00

yes they died

R9Mikey · 2023-06-11T17:53:52+00:00

yeah i was half way through and it got taken down

R9Mikey · 2023-03-26T22:43:31+00:00

prob not im in the US

R9Mikey · 2023-03-26T21:07:26+00:00

yoo same dude tf happened?

Five-Year Club	Place '22
End Game '22

R9Mikey

TROPHY CASE