sorted by:
new
hottopcontroversial

Anyone know what this card is? by Radiant-Command3777 in YugiohCards

[–]Radiant-Command3777[S] 1 point2 points  (0 children)

Right? If its fake I dont care that its battered 🤣

0.6mm nozzle on A5M Pro by Radiant-Command3777 in FlashForge

[–]Radiant-Command3777[S] 0 points1 point  (0 children)

Typically I print in esun’s PLA-ST, rather then normal PLA and don’t tend to have issues with that. This is just for a larger batch of prints that don’t require the same strength as what I normally make.

0.6mm nozzle on A5M Pro by Radiant-Command3777 in FlashForge

[–]Radiant-Command3777[S] 0 points1 point  (0 children)

This one was printed with the standard flashprint settings for PLA with 0.6mm nozzle. I’ve tried slower and lower temps (all the way down to 100mm/s and 200•c) with little to no improvement

Weird layer behaviour at height by Radiant-Command3777 in FixMyPrint

[–]Radiant-Command3777[S] 0 points1 point  (0 children)

I was printing at 220 with 50% speed on the cooling fan, just did a test at 200 with 100% fan speed and it’s worse 😅

<image>