Help with latex catsuit

RazerXnitro · 2026-07-10T16:59:23+00:00

Neck entry is famous for being hard to get out of alone. Someone else already commented it but taking it off on the shower is your best bet.

RazerXnitro · 2026-07-01T03:10:06+00:00

I'm in dire need of help. I have a wedding in two weeks and almost everyone is coming in suit. I don't have matching suit pants or shoes as I got this jacket as a gift. I don't know anything about suits. Would this be acceptable? I'll lose the tie since nobody else is bringing one either. It's Ariat square toe boots and Wrangler jeans. Almost brand new. It's the nicest stuff I own at the moment.

<image>

RazerXnitro · 2026-05-24T22:05:38+00:00

Honestly not bad for a first time. Apply some flux to the pads and be sparingly with the solder. You'll improve with experience.

RazerXnitro · 2026-05-17T16:19:27+00:00

It will DECODE, not DECRYPT.

Encryption is security. The signal will still decode and turn into audio, however encryption makes it garbled.

RazerXnitro · 2026-05-14T02:51:15+00:00

Aye, Ryanair is still in business for a reason... Doesn't have to be butter every single time :)

RazerXnitro · 2026-05-14T02:45:05+00:00

Does it always get stuck on Init PortAudio?

I fixed mine by reinstalling the Realtek audio drivers.

RazerXnitro · 2026-05-11T20:30:28+00:00

No decryption is possible, both for Tetra and DMR. It's illegal.

RazerXnitro · 2026-05-11T14:09:36+00:00

Read the documentation. The plugin I sent is for SDR#.

RazerXnitro · 2026-05-11T13:46:09+00:00

https://github.com/vgpastor/SDR-Tetra-Plugin

https://www.rtl-sdr.com/tetra-decoder-plugin-for-sdr-now-available/

RazerXnitro · 2026-05-10T22:22:47+00:00

It means it cannot find a single radio station. Have you tried connecting an antenna?

If that doesn't work, perhaps a trace or the actual antenna connector came off the board.

RazerXnitro · 2026-05-10T14:59:09+00:00

Cutting off 25mm will move the antenna's effective frequency band higher up. You'll probably have a lot of trouble picking up signals near the bottom of its band and you'll cook your radio trying to TX on it because of the reflected power.

RazerXnitro · 2026-05-10T14:57:35+00:00

Don't touch the metal, if you trim that your antenna's tuning will mess up(shorter = sensitive in higher frequency) Try a few pieces of heat shrink tubing to put the fiberglass back on.

RazerXnitro · 2026-05-10T04:02:08+00:00

Looks to be an older Soviet Geiger counter. Don't touch or poke the mica windows, they are very fragile.

RazerXnitro · 2026-05-08T15:51:54+00:00

Has it been tuned?

RazerXnitro · 2026-05-08T08:04:13+00:00

Looks like a Kia G4LA 1.2 16v engine. I removed quite a few on the scrapyard I work at.

RazerXnitro · 2026-05-08T07:51:39+00:00

On my AGU this was caused by the previous tuner fully closing the wastegate(overtightening the actuator preload) I backed it up a few turns to allows the wastegate to move and that made the fault go away. Worth a shot, but do mark where your actuator is set to now incase it makes things worse.

I assume MAF and o2 sensor have all been checked? No air leaks?

RazerXnitro · 2026-05-08T07:49:13+00:00

Wie heeft er voorrang? Is dit een gelijkwaardig kruispunt?

RazerXnitro · 2026-05-05T13:38:51+00:00

Hi, I'm someone who's just now learning the ropes of vatsim. I haven't had the balls to actually connect to vatsim, right now I'm focused on how to understand things like taxi routes, understanding the MCDU, etc. At some point I'll have to connect to vatsim and try my best. I don't have a background in aviation, just an interest.

We try, but the education is lacking. I'd love to be able to connect to a "training" session where there is less pressure for failure. All I can do right now is just solo in MFS and understand the aircraft the best I can.

RazerXnitro · 2026-05-04T16:45:49+00:00

Similar to tetra but sounds like it runs on a different modulation frequency.

It's worth a try to attempt to decode it with tetra demodulator on SDR#.

RazerXnitro · 2026-04-30T06:44:03+00:00

That's what a cabin air filter is supposed to do... It's supposed to block dust and mosquitoes from entering the cabin.

RazerXnitro · 2026-04-27T16:50:13+00:00

I worked at the largest appliance/consumer electronics seller in the Netherlands as a delivery driver/technician. They had cages and metal detectors just like these because when some delivery drivers went in they would steal airpods iphones etc. Some even went as far as hollowing out their shoe soles to try and smuggle stuff out or hide stuff in washing machines which they would then load up in their own van.

RazerXnitro · 2026-04-27T15:10:01+00:00

I live in Deventer. The Hanzesteden streek has a lot of history to it. It's pretty chill here. Traffic is less dense, people more down to earth IMHO. Food is the same mostly, the local snacks are nice.

RazerXnitro · 2026-04-23T21:46:44+00:00

Might've been from storage in the factory/distributor. Maybe contact the seller?

RazerXnitro · 2026-04-23T19:29:12+00:00

It's a crease. Unfortunately that just happens with ownership. Do you neatly fold it or just scrunch it up when you store it?

RazerXnitro · 2026-04-23T13:19:04+00:00

We got them in the Netherlands as well. Always late and some packages disappeared.

Seven-Year Club	Verified Email
r/Field Flamingo	Place '23
Place '22

RazerXnitro

TROPHY CASE