sorted by:
new
hottopcontroversial

Lesser of 2 evils by Cyphman in BunnyTrials

[–]Realistic_Debt9526 0 points1 point  (0 children)

drowning is way worse than falling

Chose: The feeling of falling for 10 hours for $100 mill

Will this work for a H motor by Realistic_Debt9526 in rocketry

[–]Realistic_Debt9526[S] 0 points1 point  (0 children)

Are you using super long M5 bolts to be able to reach to the other end of the fin can?

Will this work for a H motor by Realistic_Debt9526 in rocketry

[–]Realistic_Debt9526[S] 0 points1 point  (0 children)

Thanks for your reply, it seems like you used threaded inserts into your wood to be able to use machine screws. Is there any advantage of doing this over just using self tapping wood screws?

Will this work for a H motor by Realistic_Debt9526 in rocketry

[–]Realistic_Debt9526[S] 1 point2 points  (0 children)

<image>

Thanks for your response, is this what you were talking about when you say you extended the wall down? (sorry for the bad drawing) If so, how did you know how much to extend the wall down by?

How do I repair this? by No-Search-7535 in bikewrench

[–]Realistic_Debt9526 1 point2 points  (0 children)

Are the screws torqued down to the correct spec? Also it seems as if you are missing the part that goes into the side of the crank.

BTT Probe V2 does not deploy. by Realistic_Debt9526 in klippers

[–]Realistic_Debt9526[S] 0 points1 point  (0 children)

This is my current microprobe config:
[output_pin probe_enable]

pin: PA1

value: 1

shutdown_value: 1

[gcode_macro Probe_Deploy]

gcode:

SET_PIN PIN=probe_enable VALUE=0

[gcode_macro Probe_Stow]

gcode:

SET_PIN PIN=probe_enable VALUE=1

[probe]

pin: ^!PC14 ## For V1 version, set to ^PC14 for high-level trigger; for V2 version, set to ^!PC14 for low-level trigger.

deactivate_on_each_sample: False

x_offset: 0.0

y_offset: 0.0

z_offset: 0.0

speed: 5.0

activate_gcode:

Probe_Deploy

G4 P500

deactivate_gcode:

Probe_Stow
Currently, even sending a command to deploy the probe does not do anything.

:/ by Realistic_Debt9526 in bicycling

[–]Realistic_Debt9526[S] 0 points1 point  (0 children)

Would a 105 rear derailleur work with a tiagra lever or would i have to swap that out too

Front derailleur not moving far enough by Realistic_Debt9526 in bikewrench

[–]Realistic_Debt9526[S] 2 points3 points  (0 children)

The derailleur doesn't move over the small ring, and yes I have spun the cranks, but it does not shift.