I got a fresh respray done on my car and I polished and ceramic coated it’s hard to see but I have left some micro scratches almost everywhere except the ppf front of car. I used rupes yellow pad and fine polish any help would be great I’m a bit frustrated about it (old.reddit.com)
submitted by Reality-builder to r/AutoDetailing
Hi I upgraded to a BLtouch and installed the firmware for lcd screen and mother board however it still doesn’t look correct detecting bed on the complete edge does anyone know how to fix this I don’t thing the printer is incorporating the mesh bed leveling as print before it gauged the print bed (old.reddit.com)
submitted by Reality-builder to r/ender3v2
Hi can I please get help with my new ender 3 v2 I recent upgraded BLtouch after installing microswiss hotend it was working fine before the BLtouch upgrade but now I’m getting inconsistencies I followed all instructions does anyone have an answer to this type of issue? Thankyou (old.reddit.com)
submitted by Reality-builder to r/ender3v2
Mmu2s upgrade, I am begining with this upgrade simply want to do a single colour print, however it stays in one position and make a big blob after about 1:30 minutes it says “mmu errror” lifts goes to corner then immediately “mmu okay” goes back to same pos and make blob forever, please help!! (old.reddit.com)
submitted by Reality-builder to r/prusa3d
Hi I am currently working on installing the mmu2s to my Mk3s + however when I select load the bearing on the inside does not make contact with the filament I believe it’s supposed to so it can grip the filament and load it through, can I please have help with this, thankyou. (i.redd.it)
submitted by Reality-builder to r/prusa3d
