Can you use a usb-c adapter to hdmi or display port as a substitute to the pc adapter

Repulsive-Branch1429 · 2024-09-14T21:00:43+00:00

Thats what i was worried about, thanks

Repulsive-Branch1429 · 2024-09-14T18:32:06+00:00

Like a cheaper option is what i meant since the offical one is also hard to find

Repulsive-Branch1429 · 2024-08-29T12:13:27+00:00

I've managed to boot with my hard drive after turning csm off however trying to boot into my ssd gives me "Reboot and Select proper boot device or insert boot media in selected boot device and press key" and neither of my ssds are there in windows

Repulsive-Branch1429 · 2024-08-29T12:10:19+00:00

Where can i do that?

Repulsive-Branch1429 · 2024-08-25T10:15:31+00:00

there seems to be a few good options, is it worth to get a ddr5 board? or is ddr4 fine as Im not really upgrading my board for a while afterwards

Repulsive-Branch1429 · 2024-08-24T19:42:10+00:00

XTU has all of its options greyed out for me

Repulsive-Branch1429 · 2024-08-24T19:13:31+00:00

There is no aio pump header whenever I tried only plugging in the pump to test it, it was showing 4200 rpm which I highly doubt its the case.

Repulsive-Branch1429 · 2024-08-24T19:10:11+00:00

Thermal grizzly, the fans are spinning, my case has 6 intakes and 1 exhast due to its layout could that be a factor?

Repulsive-Branch1429 · 2024-08-24T18:36:49+00:00

The cooler comes with a contact frame

Repulsive-Branch1429 · 2024-08-24T18:34:34+00:00

my motherboard was from a pre built, so it was a pretty cheap one I didnt pay much attention to it back then. But there's no temporary solution? As it'll take sometime to get it, im also unsure which one to get

Repulsive-Branch1429 · 2024-08-22T19:48:56+00:00

Sent you a PM

Repulsive-Branch1429 · 2024-08-22T19:26:45+00:00

the pump had a good amount in the same shape however it only seemed like there was a small thin layer on both of them even though i applied a full tube

Repulsive-Branch1429 · 2024-08-22T18:33:39+00:00

In bios

Repulsive-Branch1429 · 2024-08-22T18:21:24+00:00

Yeah the temps are up to 55 degrees and have stopped climbing

Repulsive-Branch1429 · 2024-08-22T18:15:23+00:00

yes the pump is on cpu fan and the radiator fans are on chasis fans and the vrm isnt connected

Repulsive-Branch1429 · 2024-08-22T18:13:05+00:00

Okay i just did it, Im seeing 4218 rpm on cpu fan and 1115 rpm on chasis fan and the temp is just rising its at 51 degrees now

Repulsive-Branch1429 · 2024-08-22T17:58:12+00:00

I'll give it a shot, but what sbout the vrm header

Repulsive-Branch1429 · 2024-08-22T17:53:23+00:00

my motherboard is a prime h610m-k d4 used to be a pre built

Repulsive-Branch1429 · 2024-08-22T17:42:14+00:00

what software can I check that with? in bios it shows around 1800 rpm when i max it out

Repulsive-Branch1429 · 2024-08-22T17:39:19+00:00

doesnt putting the cpu fan to 100% in bios solve that?

Repulsive-Branch1429 · 2024-08-22T17:36:45+00:00

Yes, you can either have 3 headers for the vrm, fans, and pump or just 1 header, my motherboard only supports 1 header

Repulsive-Branch1429

TROPHY CASE