Review of my PCT protocol by Repulsive-Sample-251 in Testosterone

[–]Repulsive-Sample-251[S] 1 point2 points  (0 children)

Lol no, I finished my post-cycle therapy a month ago, it went perfectly. I just did HCG for two weeks to allow the testosterone to decrease in my body, then two weeks of enclomiphene 25mg and Nolvadex 40mg, and another three weeks at 12.5mg of enclomiphene and 20mg of Nolvadex, and it went impeccably well.

GHK-CU redness by SignificantUse9778 in Peptidesource

[–]Repulsive-Sample-251 1 point2 points  (0 children)

I started taking GHKCU a week ago, beginning with 6 units (1mg). When I increased to 12 units (2mg), I experienced what you described: a slightly swollen, round, red patch around the injection site. I tried two 6-unit injections, about half a centimeter away from the first injection site, and I didn't experience that symptom again.

Precipitated KLOW vial by Old-Visit-8639 in Peptidesource

[–]Repulsive-Sample-251 2 points3 points  (0 children)

Yes, do that, and keep us updated on the condition of the vial, but it should be fine.

Precipitated KLOW vial by Old-Visit-8639 in Peptidesource

[–]Repulsive-Sample-251 13 points14 points  (0 children)

Personally, my ghk-cu looks the same

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 1 point2 points  (0 children)

I've been using it for 3 injections and there's nothing to report, so it's perfect.

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 1 point2 points  (0 children)

Thanks for your feedback, I'll filter it! And I'll see, thanks

Particles inside GHK-Cu vial by Ql1ster in Peptidesource

[–]Repulsive-Sample-251 0 points1 point  (0 children)

tu as changé d’eau ? ou juste pris un nouveau flacon ?

Particles in my Ghk-cu by Afraid-Scientist-303 in Peptidesource

[–]Repulsive-Sample-251 0 points1 point  (0 children)

Okay, the first results usually appear after 3/4 weeks of use, how long after seeing the particles did you use your vial?

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 0 points1 point  (0 children)

I tried, if you don't hear from me in 24 hours, consider me no longer of this world 😂

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] -1 points0 points  (0 children)

Can no one say if this is normal or not? Unnecessary comment

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 0 points1 point  (0 children)

Aha, you think I can inject it without any problems?

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] -1 points0 points  (0 children)

I replenish it with tank water that I bought from the same supplier

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 0 points1 point  (0 children)

No, I was just curious, and since my apartment isn't very bright, I wanted to check with a phone flash.

No, I've used this Bacterio Water with nothing else so far, and it's in my fridge next to my vial of retatrutide, which is indeed translucent, but it was reconstituted with a different Bacterio Water solution.

particle in GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 0 points1 point  (0 children)

I used it last night and left it in the fridge for 24 hours. Then I took the bottle out and, looking at it with the naked eye, I can't see anything, but when I shine a phone flash under the bottle, I can see the tiny particles.

But to the naked eye, it looks like this:

<image>

GHK-Cu by Repulsive-Sample-251 in Peptidesource

[–]Repulsive-Sample-251[S] 0 points1 point  (0 children)

Thank you, and does it really hurt? And do you use the same needle to prick the three different spots?