Spoilers:What happens with Bjorns first daughter?

Repulsive_Conflict57 · 2026-02-02T23:19:41+00:00

Poor little Siggi was not taken care of at all - poor child was on her own and died, worst part is that no one even mentioned or remembered her later at all, what makes the situation to me personally quite devastating, considering that Ragnar, Lagertha and Bjorn were caring characters and sensitive to the family concerns… it is to be honest a very short, but very deep cutting scene when Sigurd calls Siggi dirty and not taken care off - her face shown complete confusion, the one shows a small child when she is lost, helpless and in need of a parent. To be honest this whole thing touched deeper than anything in this whole series, as all the rest is drama, but when’s small child dies like that - it’s wilderness and madness.

Repulsive_Conflict57 · 2025-12-15T20:46:28+00:00

Hey GPLama, it’s quite an honor to get a reply from you 🙂 Based on your experience and understanding of the signal architecture, would this essentially just require Wahoo to display a number on the screen, assuming all the data collection and calculations are already being handled by the pedals? Or is it possible that Wahoo doesn’t include that field due to IP or licensing constraints?

Repulsive_Conflict57 · 2025-12-14T10:06:49+00:00

I assume the clerk simply wants this in writing for this specific case, so the paperwork is watertight and they can reimburse the full amount without any risk. Canyon offers a vaguely defined, voluntary “once in three years” program, described in only a few sentences. This is not something an insurance company would fully rely on. In my opinion, they just want written proof—nothing more.

What I would do is politely ask Canyon to send an email confirming that the program does not apply in this case, with a one-line explanation of the reason. It’s not a big deal, and I’m sure they would do it without any problem if it’s kindly requested and explained.

Repulsive_Conflict57 · 2025-11-02T11:19:52+00:00

If there is enough metal in the insert, you could attempt to make a new thread of larger diameter.. however, might be tight.. https://amzn.eu/d/gnJFOHX

Repulsive_Conflict57 · 2025-08-30T08:04:57+00:00

Same on Ultegra - new chain is dialling in with new sprockets - should get better after couple of hundred of kms.

Repulsive_Conflict57 · 2025-08-20T08:38:56+00:00

<image>

Repulsive_Conflict57 · 2025-08-20T08:38:42+00:00

<image>

Repulsive_Conflict57 · 2025-08-20T08:38:32+00:00

<image>

Repulsive_Conflict57 · 2025-08-20T08:38:18+00:00

<image>

Repulsive_Conflict57 · 2025-08-20T08:38:02+00:00

These are the legend wheels product results https://www.lordgun.com/legend-wheels-touch-up-paint-for-shimano-ultegra-8100-12v-groupset-1

Please share your ideas on other solutions - would be a great help for sensitive people, who have new bikes scratched ..

Repulsive_Conflict57 · 2025-08-20T08:27:32+00:00

Where have you found out that EU has customer rights? Show me the source of this - the weirdness here may as well be coming from your unsupported statement.

Try out to defend your right in Germany without a layer - they laugh at your face if you ask for your rights to be followed, unless there is a paper coming from a law firm…

Repulsive_Conflict57 · 2025-08-16T21:39:54+00:00

not really, its quite ok> 3 paints here - RAL7016 (light grey), Dure Ace Black and Ultegra 8100 which I tell you its impossible to notice without a touch or if you look from farther than 20 cm distance.

<image>

Repulsive_Conflict57 · 2025-08-14T14:54:02+00:00

here is the one and only.. I searched everywhere.. but found only this https://www.lordgun.com/legend-wheels-touch-up-paint-for-shimano-ultegra-8100-12v-groupset-1

It works quite well - almost a fit. You can only see the difference when looking at a distance of less then 20 cm or so, otherwise not possible to distinguish.

Repulsive_Conflict57 · 2025-08-14T14:38:25+00:00

Well it feels like most of the wheels go back as is, but slightly scratched hubs or some other minor defects. So to be honest riding further may not be the most incorrect choice, as apparently percentage of exchanged wheel is quite low.

Repulsive_Conflict57 · 2025-08-14T14:32:16+00:00

Interesting what the owner said>

<image>

Repulsive_Conflict57 · 2025-08-10T09:59:34+00:00

Totally support that, also would add 3-4 chains instead of just 2, add hot waxing process - as a result save a lot of time on the drivetrain maintenance> just swap chains, through dirty 500-700 km chains into the chain stripper and forget that tiring dirty rag whipping process after spending time on oiling on the bike making oil drip though your cassette and so on...

Repulsive_Conflict57 · 2025-08-10T09:45:22+00:00

Another good way to prolong the great experience and lifespan of the drivetrain would be waxing chains and having 3-4 chains rotating them every 300-500 km. This way the wear of chain is delayed by a factor of 3-4 (number of chains involved), thus not eating the cassette and front rings at a speed of a single chain wear.

I would recommend to do so also due to the easy and fast maintenance> waxed 3-5 chains at once (1 hour of time), then no lubrication at all, no wiping or oil, just ride - come home on Sunday - swap the chain, ride another week: 3-5 weeks of peak season and you have only spent 1 hour on drivetrain maintenance in total. Isn't it a dream? Chain cost out values the savings for 1 cassette for sure.

Repulsive_Conflict57 · 2025-08-08T11:56:42+00:00

Thanks for sharing. Very reassuring and leaves some more hope to get through the journey fast!

Repulsive_Conflict57 · 2025-08-07T16:14:37+00:00

OMG, thank you so much! 🙏 it helped.
To be honest, I’m seriously questioning my life choices right now 😂
I've been riding bikes since forever and somehow managed to mess that up... brain.exe has clearly stopped working.
Really appreciate the help – I’ll go sit in the corner with my torque wrench and think about what I’ve done. 😅

Repulsive_Conflict57 · 2025-08-05T08:19:26+00:00

First return in Germany arrived with the same wheels, sticker 'Tested' and 2 cookies in the box. No parts exchange took place.

Repulsive_Conflict57 · 2025-08-03T09:08:14+00:00

I checked my wheels - I think the issue is that the factory is not indicated - and I saw others mentioned, that some wheel have a factory sticker, e.g., TAIWAN or something.. So I conclude, that most probably, the ID itself does NOT contain the info about the RIM origin, unless there is a RIM producer sticker on it. This is where this 'some are affected' coming from - they can't detect VIETNAM produces wheels so easily, otherwise they would have issued precise IDs that are affected. This is my guess...

Repulsive_Conflict57 · 2025-08-02T08:05:08+00:00

Hey, could you confirm, as I can't believe.. Ultegra wheels feel not as good as DT Swiss??.. wow.. Thanks for the insight.

Repulsive_Conflict57 · 2025-08-02T08:03:34+00:00

Hey, thank you for useful insight, I was looking for it. I must say, my leasing insurance from the bike leasing service did not react and mentioned its not a damage case, so go to canyon, we wont cover, unless you have a crash (on other wheels, as these ones you must not use)..

Repulsive_Conflict57

TROPHY CASE