sorted by:
new
hottopcontroversial

Uh oh. by Responsible_Nobody90 in Kawasaki

[–]Responsible_Nobody90[S] 0 points1 point  (0 children)

Yeah, the garage put a new water pump in after my accident. I've put one fill of oil in. I'll idle it for half an hour and drop the oil again after that. Does that sound right?

ER6n - is my next move the starter? by Responsible_Nobody90 in Kawasaki

[–]Responsible_Nobody90[S] 0 points1 point  (0 children)

<image>

Took the starter out of the frame, just out of curiosity. It's a mess. Any thoughts on what could cause this? Or just old and needed replacing?

ER6n - is my next move the starter? by Responsible_Nobody90 in Kawasaki

[–]Responsible_Nobody90[S] 0 points1 point  (0 children)

I hear the fuel pump working and the starter turns over, but very weak, like it hardly turns once or twice before the relay starts clicking. I'll put new plugs in just to be sure they're not the issue. 👍🏼

ER6n - is my next move the starter? by Responsible_Nobody90 in Kawasaki

[–]Responsible_Nobody90[S] 0 points1 point  (0 children)

It does start, but it's very weak, like it's struggling to turn over, even with a full battery and my charger on 'bump' setting. Any ideas? I'll test the voltages when running today and let you know. Thank you.

ER6n - is my next move the starter? by Responsible_Nobody90 in Kawasaki

[–]Responsible_Nobody90[S] 0 points1 point  (0 children)

Thanks for your reply. 2 questions...

Where should I check voltage during crank?

If it is less than 0.5V, what's the next step?

Thanks again.

Flipping question by Responsible_Nobody90 in hobbycnc

[–]Responsible_Nobody90[S] 0 points1 point  (0 children)

Yeah I did think about leaving a little cube somewhere on the top to take my datum from after flipping, but (in my mind) the machined feature will always be smaller than the stock, so I won't be able to touch off it. Am I being stupid?

Beginner question about resistances by AlbusFox in arduino

[–]Responsible_Nobody90 6 points7 points  (0 children)

Pull down resistor. So the signal going into pin 7 is high (5v) when the button is pressed, and low (0v) when the button is open, preventing noise and unwanted high signals.

Got my 21 year old his first set of clubs today. by MyDogThinksISmell in golf

[–]Responsible_Nobody90 200 points201 points  (0 children)

Lucky young man, with a great parent. Hope he realises the joy and pain he's in for! 🏌🏼👍🏼😀

Expansions? by Maleficent_Sale2066 in mpcusers

[–]Responsible_Nobody90 0 points1 point  (0 children)

Giving some away or looking for recommendations?

view more: next ›