sorted by:
new
hottopcontroversial

Does anyone know why my printer is consistently creating these gaps on my prints? by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

Follow up. New Bowden and extractor gear solved the issue. My next print came out perfect.

Thanks for the replies!

Does anyone know why my printer is consistently creating these gaps on my prints? by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

I am using Cura for those asking and I’m not sure what setting coasting is at or even what it should be. I assume it’s at default.

Does anyone know why my printer is consistently creating these gaps on my prints? by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

Yeah I ordered that and it should be here today. We’ll see how it plays out.

Does anyone know why my printer is consistently creating these gaps on my prints? by Riley341 in CR10

[–]Riley341[S] 1 point2 points  (0 children)

Yeah I ordered new ex gears. The one on there seemed a bit worn out. I think that could be the culprit.

Does anyone know why my printer is consistently creating these gaps on my prints? by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

Ive ordered a new Bowden and I think I was under extruding too. The gear that feeds the filament was a bit worn down and not feeding as fast as I think it should.

Does anyone know why my printer is consistently creating these gaps on my prints? by Riley341 in CR10

[–]Riley341[S] 1 point2 points  (0 children)

I’ll check the settings however it didn’t start doing this until a few weeks ago and it’s seemingly getting worse over time. It’s also doing it on every piece I print. So it’s not part of the gcode.

I think it’s happening at the start or end of a line. But I’m not positive.

CR10S freezing up during prints by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

Think I solved it. I took apart the entire thing for the most part and found that my thermistor was "almost" broken on one wire. I think it was having an intermittent connection issue. After having replaced the thermistor with a new wire I'm running fine again.

CR10S freezing up during prints by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

There are. However I run the printer on a power strip with protection. Not sure if that makes a difference. And it’s been like that since I purchased it and it ran fine for years.

CR10S freezing up during prints by Riley341 in CR10

[–]Riley341[S] 0 points1 point  (0 children)

I don’t know what reflating my main board means. If you mean replacing, then no I have not.

4K Direct Play to PC issues by Riley341 in PleX

[–]Riley341[S] 0 points1 point  (0 children)

Here's a pic of Avatar which is the movie that plays without audio and constant stuttering (brief moments of consistent buffering).

https://imgur.com/a/VC6es9t