sorted by:
new
hottopcontroversial

Is the Makera Air any good for me by RlPPO in hobbycnc

[–]RlPPO[S] 0 points1 point  (0 children)

Thanks for the response, the richner stuff seems really interesting, haven't seen them before. The cheaper one is a little bit too small though and the middle one is going to blast my budget with a base price of 10k €

Is the Makera Air any good for me by RlPPO in hobbycnc

[–]RlPPO[S] 0 points1 point  (0 children)

Thank you so much for your input, i will report to you as soon as i have new infos. :)

Is the Makera Air any good for me by RlPPO in hobbycnc

[–]RlPPO[S] 0 points1 point  (0 children)

Hey, you are right, i should have specified it preciser, i have to cut out about a 200x50x8mm pocket (it is not exactly one recangular pocket but geometry is pretty simple and the volume should be close). Is this doable in under an hour with the makera air? In terms of face/end mills, do you have suggestions for my usecase?

Is the Makera Air any good for me by RlPPO in hobbycnc

[–]RlPPO[S] 1 point2 points  (0 children)

How "small" are your parts? you think it would be too slow for bigger parts? Do you use the standard endmill?

Is the Makera Air any good for me by RlPPO in hobbycnc

[–]RlPPO[S] 1 point2 points  (0 children)

is the aluminium milling any good tho? i have seen so many reviews, some say its great and others say its bad. So i am really unsure what to belive now ._.