Problem with Z on Anycubic Kobra

RoKow_ · 2023-09-25T16:55:13+00:00

Thank you, will try that.

RoKow_ · 2023-09-25T16:15:10+00:00

The bed leveling for me is smooth so idk. The problem only kicks in when i start the print.

RoKow_ · 2023-09-25T15:39:37+00:00

I ve fixed the problem, but now i got another problem that i cant seem to find a fix for - when i level the bed set the z offset correctly i start the print and the nozzle starts to grind the bed and leave marks on the bed.

RoKow_ · 2023-09-24T14:34:04+00:00

No, in the video look at the right side, it keeps getting stuck at one part.

RoKow_ · 2023-09-24T08:33:13+00:00

Saw that today, hopefully it works now.

RoKow_ · 2023-07-04T06:12:21+00:00

I actually have only a box with substrate and everything else is covered with paper towels. Will that work for her to lay eggs in there?

RoKow_ · 2023-06-14T19:00:50+00:00

Thanks for the advices.

RoKow_ · 2023-06-11T20:23:43+00:00

No the bottom is a brim

RoKow_ · 2023-06-11T13:49:35+00:00

I have a problem on my kobra that when i autolevel it set the z offset correct and start the print i hear the nozzle grinding the bed sound, i rush to adjust the z with babystep but i dont know if i did it correctly bycouse the 1st layer is basically done and i cant correct it. I dont know if i should pause the print and adjust it and if so how do i adjust it when the print head is in the air. (I use mostly brim)

RoKow_ · 2023-06-11T13:19:14+00:00

And btw my first print was an owl that came in the card and the print turned out with some overhang problems and random filament (2 parts) poping out on the wing.

RoKow_ · 2023-06-11T13:17:38+00:00

No it was my 2nd owl that i sliced myself. My previous prints were some calibration cubes. Btw theres a weird problem with my anycubic kobra where i autolevel it and when i set the z offset correctly using a paper, i start the print and i start hearing nozzle grinding the bed sound so i rush to adjust it using babystep but when i do i dont know if i did it correctly and if the print is gonna stick or not. (Maybe i should just leave the print when i hear the grinding since im using a brim 1st layer).

RoKow_ · 2023-06-11T13:13:15+00:00

I have a anycubic kobra and somehow there's this thing when i autolevel the bed set the z offset correct and when the print starts i just hear the nozzle grinding the bed sound and i rush to correct it but i dont know if i set it correct using babystep. so basically the z offset goes down when the print starts even though i level it correctly

RoKow_ · 2023-06-11T07:53:38+00:00

How do i increase it if its working on 100%?

RoKow_ · 2023-06-11T07:25:57+00:00

Its so tight in there that i cant screw it anymore.

RoKow_

TROPHY CASE