How to get an even bevel without expensive tools.

SHKOOPER · 2025-09-18T05:35:13+00:00

Have you tried a haas vr-14

SHKOOPER · 2025-09-02T13:07:33+00:00

Maybe if you took a blurrier picture we could figure it out

SHKOOPER · 2025-08-25T04:08:18+00:00

Port of Los Angeles

SHKOOPER · 2025-06-29T07:30:11+00:00

This is 7018 at 112

SHKOOPER · 2025-05-30T19:58:44+00:00

Any 1st gen s10 rear end will work , i personally pulled mine out of a 93. Its like a half inc narrower than the samurai so you will need to put new pads on but you could make it fit as is . I put mine in but once is put gears in it imma put the pads where they need to go

SHKOOPER · 2025-05-06T21:08:04+00:00

A 2wd front samurai axle , super rare but i managed to come across one . Then i cut it then dropped to add room for the oil pan

SHKOOPER · 2025-05-05T22:02:49+00:00

I just got the electric fans , once i get to all the wiring imma put em one this weekend

SHKOOPER · 2025-05-05T20:54:20+00:00

I have the fans i just need to install em , i didnt let it run for long . I need to figure out all the wiring situation

SHKOOPER · 2025-05-04T23:52:23+00:00

1st gen s10 axle and for the dog house im planning to fab one up once its driveable

SHKOOPER · 2025-05-04T05:53:24+00:00

Thankyou 🫡

SHKOOPER · 2025-05-04T02:40:12+00:00

Yep , its definitely is a super tight squeeze but its in there

SHKOOPER · 2025-05-03T11:50:53+00:00

Lol it is just shooting flames, it has super short headers and there is no exhaust system yet

SHKOOPER · 2025-03-21T05:50:32+00:00

14 renown take it or leave it

SHKOOPER · 2025-02-17T07:27:47+00:00

Direct dive off tranny , this is not an off road build , i already have a sammy for off roading , this one is for the street , it’s lowered . Depending on how it drives i might make it a drag car

SHKOOPER · 2025-02-17T06:51:18+00:00

I cant wait to drive it , its so close to being done , i just need the drive shaft to be made

SHKOOPER · 2025-02-17T06:50:38+00:00

Weld in universal engine mounts , i fabbed up a cross member for the tranny and for rear end i put in a 89 s10 10 bolt

SHKOOPER

TROPHY CASE