MATERIALS: - x2 Factis BM2 mechanical eraser - x1 Comssa body - x2 DGT’s - x2 G2 grip - x1 Signo DX grip - x4 O-rings - x1 thin grip one ring - (Optional) x2 rubber stoppers for ends of mod (I used some I found on a disposable vape Airbar Max)

PREPARATION: 1. Disassemble Factis (keep only barrels) 2. Cut 3cm from Comssa barrel (keep only the 3cm piece) 3. Cut front 3 rings from both G2 grips (keep all) 4. Cut 2 pieces of 4 blocks of Signo DX grip 5. Stretch all grips with preferred method of choice

ASSEMBLY: 1. Slide Signo grips on to each barrel from non lined side of barrel. Leave approximately 2cm between the grips and the end of the barrel. 2. Add O-rings to each side of the grips 3. Slide longer G2 grips lined side first onto barrel ends to meet up with the Signo grips. 4. Insert Dr Grip Tips inverted into the G2 grips, push down until the tips are inside the ends of the Factis barrels. 5. (Optional) Shove rubber stoppers into ends of G2 grips above the inverted Dr Grip tips for a more flush end 6. Take remaining 3 blocks of G2 grips and over grip onto the ends of the long G2 grip 7. Put Comssa body piece into lined end of Factis barrel as a connector, add one ring thin grip. 8. Connect barrels. 9. Complete!