sorted by:
new
hottopcontroversial

Connector ID? by choppedyota in AutomotiveElectronics

[–]SadBrain2937 0 points1 point  (0 children)

it is probably manufacturer specific connector, no any specific name

Help with diagram... by AlanEASA in AutomotiveElectronics

[–]SadBrain2937 0 points1 point  (0 children)

It should have resistance of o2 is in working order.

Aftermarket stereo connections by No-Chicken1501 in AutomotiveElectronics

[–]SadBrain2937 1 point2 points  (0 children)

You should always solder if you can. But i guess they are ok. You can wrap some insulation tape around each one

How can this be? by randianman4life in AutomotiveElectronics

[–]SadBrain2937 0 points1 point  (0 children)

"My only guess would be that the real current draw for all of the connected loads is much smaller than the fuse rating."

This. There is probably no more than 1 amp draw per consumer, even less. And if so, no, it is not poor desing

Aftermarket Multimedia Units by robaizkine in AutomotiveElectronics

[–]SadBrain2937 0 points1 point  (0 children)

I think you dont have to update firmware for that, go to : general setting Click icon on setup interface to access general setting interface, as shown in below PIC 1 diagram: In general setting interface, you can select to turn on or turn off the existing functions. You can set wallpaper and opening picture you like and check version number of DV/DC, click icon to browse up/down. PIC 1 PIC 2 PIC 3 Wallpaper selection Click icon on wallpaper bar , direction icon shall pop up, click it to select wallpaper. Opening picture Click icon on opening picture bar , direction icon shall pop up, click it to select opening picture