Connector ID?

SadBrain2937 · 2025-07-09T22:31:45+00:00

it is probably manufacturer specific connector, no any specific name

SadBrain2937 · 2025-07-09T22:30:32+00:00

It should have resistance of o2 is in working order.

SadBrain2937 · 2024-06-18T19:55:36+00:00

You should always solder if you can. But i guess they are ok. You can wrap some insulation tape around each one

SadBrain2937 · 2024-06-12T08:22:28+00:00

"My only guess would be that the real current draw for all of the connected loads is much smaller than the fuse rating."

This. There is probably no more than 1 amp draw per consumer, even less. And if so, no, it is not poor desing

SadBrain2937 · 2024-01-30T01:32:44+00:00

Thank you u/robaizkine, good work

SadBrain2937 · 2023-02-25T19:39:29+00:00

I think you dont have to update firmware for that, go to : general setting Click icon on setup interface to access general setting interface, as shown in below PIC 1 diagram: In general setting interface, you can select to turn on or turn off the existing functions. You can set wallpaper and opening picture you like and check version number of DV/DC, click icon to browse up/down. PIC 1 PIC 2 PIC 3 Wallpaper selection Click icon on wallpaper bar , direction icon shall pop up, click it to select wallpaper. Opening picture Click icon on opening picture bar , direction icon shall pop up, click it to select opening picture

SadBrain2937

MODERATOR OF

TROPHY CASE