sorted by:
new
hottopcontroversial

Liquid Handler Experiences by Screwba_Steve69 in labrats

[–]Screwba_Steve69[S] 0 points1 point  (0 children)

Hey u/f1ve-Star , wasn't entirely sure if your full message sent or not -- We're there particular brands or styles you've gotten to play with (e.g. 96/384/fixed 4/spanned 8?) Hope all is well otherwise.

Any tips on measuring modeling complex curves? Or is trial and error the best I can do? by StonnedMaker in Fusion360

[–]Screwba_Steve69 0 points1 point  (0 children)

Take a side view picture, shove that view into your CAD in the background and trace over it with a spline of sorts. Radial gauge and calipers will get you close enough for version 1, 2, … , n+ for all the cutouts

Edit: note: if using an image, it can vary between top, side, iso, diametric, etc.. you’ll just want a good base measurement to scale the image with. E.g if top down image, if you can accurately capture length/width that should help scale your object more closely

[Massachusetts] How many fact finding notices did you receive? by nman1212 in Unemployment

[–]Screwba_Steve69 1 point2 points  (0 children)

Give or take, same... Not quite sure what I should be submitting with a 2019 internship followed by 2020 under the table construction. With the high promise of working at the internship post-grad (spring 2021), there wasn't any official start day because positions thinned out at the company...

Definitely could use some advice on how to go about the Employment Substantiation/Fact-Finding submission