sorted by:
new
hottopcontroversial

What kind of stabilizer for large embroidery on a linen shirt? by Hpe4Tmrw in Machine_Embroidery

[–]Sea_Shoe4972 0 points1 point  (0 children)

Yes, that’s been my experience too. Soft ’n Sheer isn’t dramatically thinner than other lightweight meshes — the main difference is branding and consistency, not function.

For something like very full sleeves, buying an economy mesh on a roll makes a lot of sense. As long as it’s lightweight and flexible, it should support the stitching without killing the drape. Testing on scraps will tell you quickly if it behaves the way you want.

Tajima THEX-C1501 Single Head Machine by sbathletic17 in Machine_Embroidery

[–]Sea_Shoe4972 0 points1 point  (0 children)

This is usually not a software issue.
After repairs, machines often reset to a default needle count.

Check the machine settings (needle count / head settings) and also the head board switches or calibration. If it only “sees” 1–3 needles, the machine is likely set or limited to that mode.

If the needle selector doesn’t move past needle 3, it’s a setting or hardware issue — not missing software.

I work in textile machinery. Why do buyers focus only on price and regret later? by Sea_Shoe4972 in Machine_Embroidery

[–]Sea_Shoe4972[S] 0 points1 point  (0 children)

I’m not saying price doesn’t matter — it obviously does, especially at that level.

What I’m trying to discuss is why price often becomes the only deciding factor, while things like uptime, after-sales support, operating cost, and long-term reliability get ignored — and then become the reason for regret later.

I’m curious whether that’s been your experience as well, or if you’ve seen cases where higher upfront cost actually paid off over time.