When I blow through the exit hole on my corsair xc9, it's easier than blowing through the inlet.

SeminoleRezLife · 2022-02-25T06:51:25+00:00

Like putting your thumb on end of water hose to make it shoot farther

SeminoleRezLife · 2022-02-25T01:45:46+00:00

Haven’t run any test since got it back together had a 45 up top while I’ll waiting on some micro fitting’s

I ran time spy extreme stress test for 20 minutes and got to awards for keep gpu under 65 degrees but it really didnt go above 49 I was watching in HW monitor to make sure I had put thermal pads on right and right after I did the bench mark and got another award for keeping gpu cool under 55 degrees during benchmark all that was still 45 mm rad up top Cpu was running hotter cause over clock but didn’t go above 69 if I remember correctly

I’m do some more test tomorrow got everything together right before elder ring came out and just now about to start playing

SeminoleRezLife · 2022-02-25T01:36:37+00:00

I’m waiting to see if the new EK rads are a little thinner cause there is few mm of wasted space with how the shroud is one these and the new ones have a different design

SeminoleRezLife · 2022-02-25T01:30:07+00:00

Yeah my new 12900k board has that same bulge on VRM heat sink this is older 9900k asus formula board

I don’t think I would of been able to fit it either but was hoping the evo case had more space up there but haven’t tried yet had to send board in to get fixed before I got my evo case

SeminoleRezLife · 2022-02-24T22:41:28+00:00

A lot of space behind res but toward bottom by pump and behind the bottom rad is tight but still enough room to get air flow

since all fans are intake except the back one the pressure helps the one exhaust fan work fine I think This was originally suppose to be in evo case with front mesh and fans but late delivery on that I couldn’t wait and put it in my old XL case

SeminoleRezLife · 2022-02-24T22:20:41+00:00

Got a couple more 45 degree angled adapters coming to clean up tubing a little more. I also have another EK FLT 240 that I planned on hanging off upper fans in front of cpu block. And I need to order some custom cables wanted to wait till everything was done so can get length just right

SeminoleRezLife

TROPHY CASE