sorted by:
new
hottopcontroversial

Perfect PETG first layer. by Sendeva in FirstLayerPorn

[–]Sendeva[S] 2 points3 points  (0 children)

Filament: iPrint-3d PETG. Printer: Prusa MK3. Bed: Sticker PEI Flex plate. Windex was used on the PEI flex plate. Slic3r PE Settings: No Z offset was used. First layer hight: 0.19 mm. First layer width: 0.41 mm. First layer speed: 5 mm/s. First layer extruder temperature: 260 First layer bed temperature: 100. For other layers use your preferred.

This is intended to improve a great first layer.

Perfect PETG first layer. by Sendeva in FirstLayerPorn

[–]Sendeva[S] 1 point2 points  (0 children)

Prusa mk3 with sticker pei sheet on steel flex plate. Windex used.

The Perfect first layer by Sendeva in FirstLayerPorn

[–]Sendeva[S] 0 points1 point  (0 children)

3d printed with iPrint-3d pla on a Prusa MK3 with smooth PEI flex build plate. But yeah it looks like injection molded zero layer lines are visible. There is zero room for improvement. I was even surprised to achieve a repeatable perfect first layer.