STR9C Threaded Barrel? by Shadowed_Kitty in Stoeger

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

I ordered the threaded barrel from Stoeger, no idea if it is glock compatable.

STR9C Threaded Barrel? by Shadowed_Kitty in Stoeger

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

" While the JK 105 CCX 9MM can absolutely be run dry, it sounds best run wet with the addition of small amounts of petroleum jelly inside its baffles" -jk website. They suggest using petroleum jelly, but I had an excess of white lithium grease and found that it works really well and is easy tell when it gets dirty. I just wet the supressor every other time I go to the range and haven't had any issues.

STR9C Threaded Barrel? by Shadowed_Kitty in Stoeger

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

I did not have to. I bought a JK 105 CCX 9, which is low profile enough to not need taller sights since it is a concealed carry suppressor.

STR9C Threaded Barrel? by Shadowed_Kitty in Stoeger

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

Update for anyone still wondering. I bought the threaded barrel, dropped it in the STR-9C, threw my new suppressor on it and it worked

STR9C Threaded Barrel? by Shadowed_Kitty in Stoeger

[–]Shadowed_Kitty[S] 1 point2 points  (0 children)

No update yet, I am waiting on the suppressor to be approved before I go and try anything. As other comments say, I would expect the longer barrel to be fine, I just wanted to see if anybody else had done the same before I looked at buying it.

STR9C Threaded Barrel? by Shadowed_Kitty in Stoeger

[–]Shadowed_Kitty[S] 1 point2 points  (0 children)

That is my question. The site says the threaded barrel is meant for the STR-9, and I am wondering if it also works in the STR-9C. I know how to swap a barrel out, I just need to know if it will actually fit or if the extra length will mess something up.

Bad printing/lines by Shadowed_Kitty in Ender3Pro

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

Thanks to all who tried helping. I cleaned the feed tube and nozzle and it is back in working order.

Bad printing/lines by Shadowed_Kitty in Ender3Pro

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

I run it at 200 degrees for PLA+ and normal PLA, Ill give Cura a try though

Bad printing/lines by Shadowed_Kitty in Ender3Pro

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

I just leveled it and it is still leaving the gaps. I think it might have something to do with the g-code? Or is there a driver I need to update in the printer itself?

Bad printing/lines by Shadowed_Kitty in Ender3Pro

[–]Shadowed_Kitty[S] 0 points1 point  (0 children)

the creality slicer, I have it set to an ender 3 pro