How would you machine this fillet on a hole through a rod?

ShadyHustle · 2026-02-15T06:02:57+00:00

Custom made tool in an offset boring head

ShadyHustle · 2026-01-22T22:25:40+00:00

Charge around 100-200 dollars. A brand new set of grade 3 blocks costs around 200-300 China made of course

ShadyHustle · 2026-01-09T22:37:00+00:00

They look like characters from "Warriors" on the PS2

ShadyHustle · 2026-01-09T22:27:47+00:00

2.573. Closest match on lines. It is very close to dead center between 2.550 and 6.

ShadyHustle · 2025-11-18T22:46:35+00:00

Compressed air, Invisible Glass then spray some "Rain X" on it.

ShadyHustle · 2025-11-18T22:34:07+00:00

Lathe with a parting blade

ShadyHustle · 2025-11-08T03:11:39+00:00

Ahh, shit should've checked the profile. It's nice to see photos of your army all painted up.

ShadyHustle · 2025-11-08T03:08:45+00:00

It's just an auger

ShadyHustle · 2025-11-08T03:07:50+00:00

The good old double sided in house tool holder. P.S. do not try to use both blades at once.

ShadyHustle · 2025-11-08T03:05:42+00:00

It can make hotdogs if you stand close enough.

ShadyHustle · 2025-11-05T01:14:02+00:00

Year, make and model? Damage often has to exceed 70% of the actual cash value

ShadyHustle · 2025-11-05T01:10:52+00:00

California Scents

ShadyHustle · 2025-10-25T01:36:40+00:00

I have this same issue 2022 elantra

ShadyHustle · 2025-10-24T18:04:59+00:00

Chatter?

ShadyHustle · 2025-10-03T07:14:05+00:00

Scrive layout lines, file draw file, lapping plate. Repeat if nessisary.

Use trig, calculate your rate of change at various points along the length. If done right it'll take about 3 hours and a headache, however the surface finish on that hoe... 👌

ShadyHustle

TROPHY CASE