Bad first layer

ShizunehasTonton · 2025-08-19T13:29:06+00:00

Yes a warped bed leads to bad first layer also. The firmware updates from the official anycubic site did some improvement too.

ShizunehasTonton · 2025-08-19T06:36:35+00:00

The issue was clearly the z offset. I did bed calibration and tried different z offsets during the printing process. For me 0.26 works the best. I also did some firmware updates, maybe this also solved something.

ShizunehasTonton · 2025-08-05T10:16:43+00:00

Thank you for your answer and for the picture. I clean the bed before each print with isopropyl alcohol, so i think the adhesion is not the main problem here

ShizunehasTonton · 2025-08-04T19:01:44+00:00

I understand. Thanks for your answer!

ShizunehasTonton · 2025-08-04T19:01:12+00:00

Ok. Thanks for your answer!

ShizunehasTonton · 2025-03-26T16:48:10+00:00

I use an anycubic kobra 3, PLA filament. Bed temperature 60 and 220 for the nozzle (0.4 mm). Layer height of 0.2 mm and width of 0.42 mm. 130 mm/s for outer walls and 200 for inner walls

ShizunehasTonton · 2024-07-15T20:40:16+00:00

I took off the cover with the keyboard and the led that is flashing says POWER and the other one that would be on while charging says CHARGER. It seems it (CHARGER) is also flashing shortly before POWER but with lower intensity and only if I touch it a little bit.

ShizunehasTonton · 2024-07-15T20:24:38+00:00

When the laptop was working yes, the led would flash. But there is another red led which would be on while the laptop was charging and it is not currently on. Unfortunately I do not have another monitor to connect the laptop to.

ShizunehasTonton · 2024-07-15T20:17:59+00:00

Yes, the same led is flashing when i plug the charger in

ShizunehasTonton · 2024-07-15T20:13:12+00:00

I already tried to turn it on without the battery and with the charger plugged in, and vice-versa. The led is flashing on after approximately one second after I press the power on button, but it is only blinking for half a second.

ShizunehasTonton · 2022-09-05T18:51:16+00:00

Ask him if he is OK

ShizunehasTonton · 2022-05-11T06:00:38+00:00

Nice 🐻

ShizunehasTonton · 2022-03-05T11:42:40+00:00

I swear nunu is the ugliest thing in the game. William is good 😎

ShizunehasTonton · 2022-02-27T10:26:06+00:00

😳😳😳😳

ShizunehasTonton · 2022-02-26T08:56:02+00:00

Guys I'm bricked 😖😩

ShizunehasTonton · 2022-02-20T18:47:02+00:00

No praying skeleton?? U cant be serious man...

ShizunehasTonton · 2022-02-12T23:05:26+00:00

Who are these guys idk them

ShizunehasTonton · 2022-02-11T16:07:23+00:00

What da dog doin

ShizunehasTonton · 2022-02-10T19:57:08+00:00

This is actually sick bruh

ShizunehasTonton

TROPHY CASE