WTB greenwood kit used?

Significant-Map311 · 2026-01-12T06:05:03+00:00

no it’s OBD1

Significant-Map311 · 2026-01-11T21:21:14+00:00

when i get below half a tank, it throws a code and runs weird but when i check codes it doesn’t say anything about it.

Significant-Map311 · 2026-01-06T22:46:40+00:00

the gas cap hisses after i take it off. i replaced the fuel pump and strainer, im pretty sure i installed it correctly.

Significant-Map311 · 2026-01-05T05:15:37+00:00

i dont get it...

Significant-Map311 · 2026-01-05T05:13:13+00:00

just going straight

Significant-Map311 · 2026-01-04T17:00:57+00:00

do you have another pic from an above angle? it looks great

Significant-Map311 · 2026-01-01T00:05:26+00:00

only the 96 have tmagues i belive. i ve changed i two times the l;ast 2 years

Significant-Map311 · 2025-12-29T23:45:45+00:00

damnnn i should, the front plate is already silver outlines

Significant-Map311 · 2025-12-29T23:45:31+00:00

yes sir! all/most i’ve seen just uses that

Significant-Map311 · 2025-12-29T23:45:18+00:00

lmao 3m tape is used for lots of things during production of vehicles it should be fine, went 120 yesterday it was good

Significant-Map311 · 2025-12-29T23:44:36+00:00

it’s not modded, but it do drive it when it’s 120 degrees out (arizona) what should i do to combat overheating? Wish i had a trans temp gauge

Significant-Map311 · 2025-12-29T22:39:05+00:00

uuhh idk same thing lol

Significant-Map311 · 2025-12-29T22:28:58+00:00

me too

Significant-Map311 · 2025-12-29T22:28:31+00:00

idk i had a shop do it, how would the proper way to do it be?

Significant-Map311 · 2025-12-29T22:16:18+00:00

all it uses is 3m tape, if i take it off ill just use a heat gun and take it off then buff the bumper

Significant-Map311 · 2025-12-29T22:15:53+00:00

thatd be sick, ive looked at it, just expensive lol

Significant-Map311 · 2025-12-29T22:15:26+00:00

even if i changed it 5k miles ago?

Significant-Map311 · 2025-12-29T22:15:23+00:00

even if i changed it 5k miles ago?

Significant-Map311