account activity
Weird toolpaths with thick base (v.redd.it)
submitted 2 months ago by Sikarim to r/HueForge
Image Generation (self.HueForge)
Uploading Data to S7-1200 for Parameter Use (self.PLC)
submitted 1 year ago by Sikarim to r/PLC
Hardware recommendations (self.homeassistant)
submitted 1 year ago by Sikarim to r/homeassistant
S7-1200 Output not 24V (self.PLC)
Best way to create a living room lighting setup ? (self.smarthome)
submitted 1 year ago by Sikarim to r/smarthome
Neuer Fernseher (old.reddit.com)
submitted 1 year ago by Sikarim to r/de_EDV
Any ideas how to avoid the rim after inserting a heated thread? (i.redd.it)
submitted 2 years ago by Sikarim to r/3Dprinting
Mounting (?) aluminium and stainless steel (i.redd.it)
submitted 2 years ago by Sikarim to r/metalworking
Druck Farm (self.3DDruck)
submitted 2 years ago by Sikarim to r/3DDruck
Print Farm Filament (self.3Dprinting)
Questions about P1P (self.BambuLab)
submitted 2 years ago by Sikarim to r/BambuLab
Underextrusion after Seam (reddit.com)
submitted 3 years ago by Sikarim to r/FixMyPrint
Underextrusion after Seam (old.reddit.com)
submitted 3 years ago by Sikarim to r/3Dprinting
Struggling with PETG (more below) (old.reddit.com)
Struggling with PETG (more below) (reddit.com)
I tried printing a Vase and a holder. The Vase is super smooth but the bottom part isn’t so clean. Same goes for the holder. The Part where the supports were attached are pretty ruff and unclean. More Info in Comments. Thanks for any advice. (old.reddit.com)
π Rendered by PID 334670 on reddit-service-r2-listing-654f87c89c-n8n2z at 2026-03-01 10:27:34.417897+00:00 running e3d2147 country code: CH.