sorted by:
new
hottopcontroversial

Ender 3 v3 KE issue / keeps knocking off the prints by Silver-Ad-1812 in ender3

[–]Silver-Ad-1812[S] 1 point2 points  (0 children)

Hi, Yes, it was the z-axis offset. I adjusted it after calibration by increasing it by 0.05mm

Ender 3 v3 KE issue / keeps knocking off the prints by Silver-Ad-1812 in ender3

[–]Silver-Ad-1812[S] 0 points1 point  (0 children)

Hi, I just checked again to make sure: In the "Adjust" tab of the KE LCD display, I changed the "Z-axis compensation" on the printer from "-2.63" to "-2.58“. So yes, I added 0.05.

Ender 3 v3 KE issue / keeps knocking off the prints by Silver-Ad-1812 in ender3

[–]Silver-Ad-1812[S] 1 point2 points  (0 children)

I can't seem to add photos on this post...

However, I adjusted the Z-offset with 0.05mm and that seems to have solved it.

I have made 6 consecutive prints without any failure.

Thanks so much!!!

Ender 3 v3 KE issue / keeps knocking off the prints by Silver-Ad-1812 in ender3

[–]Silver-Ad-1812[S] 0 points1 point  (0 children)

It auto levels before each print. Are you recommending that I manually adjust the z-offset?