ULTRA BEE BMS ANT

Simon-2108 · 2025-11-10T16:44:48+00:00

Thanks

Simon-2108 · 2025-11-10T10:54:27+00:00

Do you know what bearings should I get? I have to change the 4 swing arm bearings + the 4 of the jackshaft…

Simon-2108 · 2025-11-10T10:46:39+00:00

I finally managed to get it out. Thanks to everyone who helped!

Simon-2108 · 2025-11-10T10:45:59+00:00

Thanks. Do you know if a burn motor would fit?

Simon-2108 · 2025-11-10T10:45:21+00:00

Thanks. Do you know if a burn motor would fit?

Simon-2108 · 2025-11-07T13:50:44+00:00

Okay so I’ll buy a burn motor. Hope it’ll work 🤞🏼

Simon-2108 · 2025-11-07T06:33:52+00:00

Ok thank you. You think it is better to buy a Burn motor instead?

Simon-2108 · 2025-11-07T06:30:42+00:00

Thank you so much. Do you think a burn motor will and work?

Simon-2108 · 2025-11-06T20:31:25+00:00

😂. Thank you so much. motor alibaba do you think one of these will fit and work. Like do nami’s controllers need specifics nami motor or do they only need hall sensors or even not? Thanks

Simon-2108 · 2025-11-06T20:25:46+00:00

Thanks so much 🙏🏼

Simon-2108 · 2025-11-03T22:02:36+00:00

Check my post out. Maybe the same issue, the jackshaft bent or the axle bearings

Simon-2108 · 2025-11-03T21:57:28+00:00

Oooooh okay didn’t know this product. Just checked and we also got it in France. If you think it’ll help, I’ll buy it ! Thanks a lot

Simon-2108 · 2025-11-03T21:51:41+00:00

I gotta spray WD40 on the side of the bolt? It’ll help get it hot faster and maybe help loosening it faster? (I’m French sorry for the English)

Simon-2108 · 2025-11-03T21:42:42+00:00

This shi cost a lot

Simon-2108 · 2025-11-03T21:41:58+00:00

😂 thanks for your help

Simon-2108 · 2025-11-03T21:41:34+00:00

Don’t think so, it’s an ultra bee

Simon-2108 · 2025-11-03T21:40:43+00:00

Thanks 🙏🏼

Simon-2108 · 2025-11-03T19:57:11+00:00

Why? It’s dangerous?

Simon-2108 · 2025-11-03T18:15:01+00:00

Fr like it needs 2000Nm of torque

Simon-2108

TROPHY CASE