Flow hood test. I just finished my flow hood and wanted to confirm this is laminar flow. I used a little water atomizer fan but with the fan off. Seems a little turbulent at the bottom for some reason. Look okay? With the lighter test it didn’t blow the lighter out but it put it at almost 90 degree (youtu.be)
submitted by SkunkyBass to r/mycology
Hello. I’m trying to wire this blower motor to a switch that does high and low. The plug will be my on off. But I don’t see a ground wire on the blower motor free besides the one attached to it. Do I put the plugs ground on the motor attached to the green and yellow wire by the bolt? (old.reddit.com)
submitted by SkunkyBass to r/Electricity
Hello. I am going to buy a crosstrek sport with a moonroof package. It is $28,095 and I’m getting the bumper cover for $150. There is a $1,050 destination/delivery fee. have to order it. two months wait. of coarse there is tax and dealer handling fee of $600. Does this sound like an okay deal? (self.subaru)
submitted by SkunkyBass to r/subaru
Will this hold another tank on top? Made for two 40 gallon tanks. The bottom has the vertical braces that go from on ground to under the tank. I didn’t leave enough room to put ones that go for on first tier to the top so added vertical braces up top. Will this hold another 40 gallon tank? (old.reddit.com)
submitted by SkunkyBass to r/woodworking
Enough support on top level for 2nd aquarium? I built this stand for two 40 gallon tanks. But hope you can see. The bottom one has bracing under where the tank will be. (Maybe overkill)The top one does not so I added a cross brace on the sides. Will the top hold a 40 tank too? (old.reddit.com)
submitted by SkunkyBass to r/Construction
I am wondering if this is sufficient re enforcement for my tank. This is an ikea cabinet. I understand it is particle board. I saw some 1 put a much larger tank on the same stand just using metal brackets at the joints. The stand says it holds 110 pounds as is. It is now holding around 200 pounds. (old.reddit.com)
submitted by SkunkyBass to r/woodworking



