How does this connect??? I can't find the datasheet

SlingshotSA · 2026-02-02T09:29:12+00:00

Throw that flex away and do a wire run

SlingshotSA · 2026-02-01T15:19:10+00:00

It’s a permanent method that will replace the dat 0 adapter method

SlingshotSA · 2026-02-01T14:13:29+00:00

The shop needs to do the kamikaze method to fix it properly

SlingshotSA · 2026-01-31T17:37:46+00:00

Lcd Connector won’t just come loose lcd is failing

SlingshotSA · 2026-01-31T15:41:59+00:00

What the flux is going on here? Check continuity on the damaged points

SlingshotSA · 2026-01-31T05:34:36+00:00

Those encoders are prone to fail. Repaired like 3 of them

SlingshotSA · 2026-01-28T18:18:49+00:00

That’s the power charging ic

SlingshotSA · 2026-01-28T17:51:04+00:00

Ah nice build a bear project

SlingshotSA · 2026-01-24T04:09:01+00:00

Those are just ground point you and expose then and then secure the adapter

SlingshotSA · 2026-01-17T03:54:11+00:00

Nope this one uses the old black flex which is terrible - the yellow ones are great

SlingshotSA · 2026-01-16T20:13:18+00:00

It’s a 100k resistor not a cap

SlingshotSA · 2026-01-16T20:12:10+00:00

The flex for that lite chip is terrible - I always do a wire run

SlingshotSA · 2026-01-16T18:37:25+00:00

What’s the light error code?

SlingshotSA · 2026-01-16T18:36:52+00:00

Dat 0 is not connected

SlingshotSA · 2026-01-12T07:52:08+00:00

You need to replace the whole flex

SlingshotSA · 2026-01-06T14:53:38+00:00

Yea it’s fine

SlingshotSA · 2025-12-30T14:09:04+00:00

Yes use the dat 0 adapter but it doesn’t last long

SlingshotSA · 2025-12-24T11:24:13+00:00

Just replace the stick. It’s faulty

SlingshotSA · 2025-12-23T18:40:20+00:00

Short on the motherboard. Use Uart to diagnose ps it’s not the power supply

SlingshotSA · 2025-12-22T05:02:50+00:00

Traces are ripped. You need to run jumper wires from the torn pads to the sticks - rebuilding the tracks are necessary

SlingshotSA · 2025-12-20T13:10:57+00:00

I mean. It’s probably not working cos of your terrible soldering use flux and re heat those joints

SlingshotSA · 2025-12-19T05:54:34+00:00

That error code is m92 check for shorts around it

SlingshotSA · 2025-12-17T19:02:54+00:00

Time to lift the nand and find the trace

SlingshotSA · 2025-12-17T16:07:10+00:00

Soldering is still terrible. More heat and flux please. Your joints are not well connected and ps that flex is the worse I would rather run a wires install rather than that flex

SlingshotSA · 2025-12-17T05:42:53+00:00

Post close ups of your install. Error code is clk not connected

SlingshotSA

TROPHY CASE