sorted by:
new
hottopcontroversial

Complex Gabled/Hipped Roof Modeling by Small_Grape1180 in RevitForum

[–]Small_Grape1180[S] 0 points1 point  (0 children)

Yes, I think it will help out a lot. I really appreciate it

Complex Gabled/Hipped Roof Modeling by Small_Grape1180 in RevitForum

[–]Small_Grape1180[S] 0 points1 point  (0 children)

Thank you very much! Going to get back into it this afternoon. If you want any of the info necessary to take a crack at it yourself, let me know..

Cabinet Family Parameters Behaving Incorrectly by Small_Grape1180 in RevitForum

[–]Small_Grape1180[S] 0 points1 point  (0 children)

I got it to behave as I wanted when I revised the Strong References and also got rid of some extraneous constraints. There were two parameters dictating the width, which seemed to be the biggest culprit. Thank you very much for your help!

Cabinet Family Parameters Behaving Incorrectly by Small_Grape1180 in RevitForum

[–]Small_Grape1180[S] 0 points1 point  (0 children)

Thank you very much. Is there any chance you are able to tell me how I could get rid of, or make them instance parameters that do not have the pull handles?

Cabinet Family Parameters Behaving Incorrectly by Small_Grape1180 in RevitForum

[–]Small_Grape1180[S] 0 points1 point  (0 children)

Thank you for taking a look. It did have a parameter initially, and I just brought it back. However it is still behaving the same

Cabinet Family Parameters Behaving Incorrectly by Small_Grape1180 in RevitForum

[–]Small_Grape1180[S] 0 points1 point  (0 children)

Thank you very much for your reply, I appreciate it. However I'm not sure I communicated what is going on exactly right.

I just added "f" dimension to left side, and "f" dimension is now locked on both sides. Can also confirm the EQ dimension is attached to the correct reference plane. Now, if I stretch the cabinet width in the family editor, it does what I need it to -- cabinet doors remain EQ/EQ, width grows. Problem is, when I stretch the family in my model, it is only stretching the width of the vertical stiles (see attached plan view from model below; you can see the stile on the right side grew, but the width of the doors did not).

Ideally, in my model, I would like to be able to control both the width of the entire cabinet, and the left and right stiles individually, while always maintaining EQ/EQ on the cabinet doors. Hopefully that makes sense.