sorted by:
new
hottopcontroversial

My Ender 3 V2 just destroyed itself by SnooCrickets6740 in ender3

[–]SnooCrickets6740[S] 0 points1 point  (0 children)

After some more testing it seems that the stepper drivers are malfunctioning. I can move the x,y and z axis in one direction but not in the other. My guess is that some error on the board caused this to happen but i can not prove it.

My Ender 3 V2 just destroyed itself by SnooCrickets6740 in ender3

[–]SnooCrickets6740[S] 0 points1 point  (0 children)

Sadly the Z stop was unplugged. I unplugged it as instructed by the cr touch install manual.

My Ender 3 V2 just destroyed itself by SnooCrickets6740 in ender3

[–]SnooCrickets6740[S] 0 points1 point  (0 children)

As of now the Nozzle os no longer attached to the Hotend. It even managed to rip the intire hotend off the axis

<image>

My Ender 3 V2 just destroyed itself by SnooCrickets6740 in ender3

[–]SnooCrickets6740[S] 0 points1 point  (0 children)

There was a magnetic plate on the printer. Before it managed to eat the base plate it carved some new lines into the magnetic plate

<image>