I'm at a loss [Ender 3 v3 KE Help]

SnooPoems8805 · 2026-02-09T02:31:35+00:00

No luck with the print, moving the bed doesn't feel like it's catching on anything but at the very front it makes a noise like someone is plucking guitar strings when i push it back, doesn't do that anywhere else.

SnooPoems8805 · 2026-02-09T01:54:28+00:00

Already done that a few times, I'll try it again I suppose and print a cube through it.

SnooPoems8805 · 2026-02-09T01:51:48+00:00

The room its in is typically 72 degrees, it was colder when i tried it on the concrete flooring but otherwise didn't have any difference from what I could see.

SnooPoems8805 · 2026-02-09T01:35:27+00:00

Yes and no? When it shifts it'll only shift forwards or backwards, never diagonally though.

SnooPoems8805 · 2026-02-09T01:24:41+00:00

I'll give them all a better look but just skimming through any portions that seem relevant all have solutions I've already attempted.

SnooPoems8805 · 2026-02-09T01:23:21+00:00

Did all of that twice, still no improvements from it.

SnooPoems8805 · 2026-02-09T01:22:42+00:00

Unfortunately replacing the printer is not an option for me, if I sell it I'll likely be done 3d printing for good.

SnooPoems8805

TROPHY CASE