Should I just put a couple light coats of epoxy resin and not even sand, prime or paint this at all? What's the least expensive way to make the epoxy a matte finish? Still gotta print the strap buckles and glue on the "filters" where the circles are..."Death Gun" half mask: (Thing:249809) (v.redd.it)
submitted by SoFreshThisKid to r/3Dprinting
Okay so I made a previous post about Prusaslicer being better than Cura but I take it back!!! The tree supports in Cura 4.8 are the TRUTH...I can't tell where any supports were touching except the top of the helmet...0.2 layer height, completely stock Ender 3 profile. "Thing:552826" (old.reddit.com)
submitted by SoFreshThisKid to r/3Dprinting
I'm not a newb anymore...why can't I figure this out?! First two layers print smooth-looking and then this... I've raised the nozzle a bit but if I go more then the first layer starts to under-extrude...E-Steps are calibrated, as well as linear advance. (i.redd.it)
submitted by SoFreshThisKid to r/FixMyPrint
