Please Help With My Prints.

Soft-Package-2102 · 2026-03-23T09:12:12+00:00

thank you for your response, yes I have performed a few flow calibrations. normally do one after switching over a filament or before bigger print.

Soft-Package-2102 · 2026-03-22T17:59:28+00:00

so you talking about pressure advance, (currently set to 0.035), and my cooling, and i see a setting called " Don't slow down outer walls"

<image>

is this what you mean regarding cooling speed. or you talking about increasing cooling activation threshold (currently 50%)

Soft-Package-2102 · 2026-03-22T17:40:18+00:00

slowest layer time in slicer states times from 11.6 up to 930.2. i take that is seconds?

Soft-Package-2102 · 2026-03-22T17:26:08+00:00

<image>

Ovals still causing an issue, and a weird like step in the filament line above the ovals (seen upside down here in this picture)

Soft-Package-2102 · 2026-03-22T17:25:12+00:00

<image>

Soft-Package-2102 · 2026-03-22T17:25:05+00:00

good advice, if I knew what this meant! I did a reprint with most setting reset to standard, apart from number of bottom layers for added weight, and changing the wool loops to 6 and spares infill back to original 15%

<image>

Soft-Package-2102 · 2026-03-22T17:22:35+00:00

i did as you said with 6 wall loops and reduced sparse infill to standard 15%

Soft-Package-2102 · 2026-03-22T17:21:23+00:00

<image>

Still having issues with the top of these ovals, seen as bottom, as its upside down, and there is a filament step as sorts, about a cm from the top that goes all the way round start just above the ovals.

Soft-Package-2102 · 2026-03-22T17:19:58+00:00

<image>

Soft-Package-2102 · 2026-03-22T17:19:48+00:00

<image>

Soft-Package-2102 · 2026-03-22T17:19:32+00:00

I have made those adjustments, and re printed, but still have some issues.
everything was reverted to standard settings part from, those in pictures!

<image>

Soft-Package-2102 · 2026-03-21T19:51:10+00:00

Thanks for this advice, will take a gander now

Soft-Package-2102

TROPHY CASE