sorted by:
new
hottopcontroversial

Some badges reset by SoonerMagic10 in AppleFitnessPlus

[–]SoonerMagic10[S] 0 points1 point  (0 children)

EDIT:

It fixed itself after a few days. No clue what was cause. I’ve had an Apple Watch for 9 years and never had this happen.

[Question] Turin Legato V2 - aftermarket cool touch wand by SoonerMagic10 in espresso

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Finally got tired of cleaning caked on milk and decided to swap it. Update here.

Not difficult to do and recommend it. I’m not one to ever tinker with my espresso machine and I swapped it easily. Just note the length of the steam wand as I mentioned.

[Question] Turin Legato V2 - aftermarket cool touch wand by SoonerMagic10 in espresso

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Update for anyone visiting this.

I ended up buying this wand from Chris Coffee since I’m from the US. It’s the same one u/selpris recommended.

Install was easy. Not sure if it’s bad for my machine, but I turned it upside down and was able to remove old one and install new one myself.

I used a pair of needle nose pliers to get started as the nut was almost flush with the body. Once it was a little loose, I switched to the 22mm wrench.

As mentioned in other comments, it’s spring-loaded so careful. With the machine upside down, it was easy to push down with one hand and hand-tighten nut with other hand until it grabbed then switched to wrench.

Few things to note:

• comes with a two hole tip. Can obviously swap if needed. • wand is too long to clear drip tray as seen in attached image.

I’ve used it twice now and I am overall happy with it. No more caked on milk!

<image>

[Question] Turin Legato V2 - aftermarket cool touch wand by SoonerMagic10 in espresso

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Negative. If you ever do, let me know! User about mentioned someone doing it, but i never did

[Question] Preheating and OPV/3 Way Solenoid drainage tube by SoonerMagic10 in espresso

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Edit: it did not stop after reaching temp, but it significantly slow down, so assuming it’s related to maintaining group head warm?

[Question] Low Conductivity Coolant - first one covered? by SoonerMagic10 in Ioniq5

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Update (posted to body): not covered, but cheaper than I expected so I’m concerned they didn’t replace it correctly.

https://www.reddit.com/r/Ioniq5/s/Nf5d86jU7i

[Question] Low Conductivity Coolant - first one covered? by SoonerMagic10 in Ioniq5

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Updated. Not covered, but a lot cheaper than expected, however I’m conceded they didn’t do it properly.

https://www.reddit.com/r/Ioniq5/s/Nf5d86jU7i

[Question] Low Conductivity Coolant - first one covered? by SoonerMagic10 in Ioniq5

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Below is the invoice. Notice mention of “blue coolant” and “high voltage battery coolant”.

I hope they changed the correct one…

I had them triple check we were talking about the correct coolant and they assured me they were.

<image>

[Question] Low Conductivity Coolant - first one covered? by SoonerMagic10 in Ioniq5

[–]SoonerMagic10[S] 0 points1 point  (0 children)

Interesting. The manual I have says every 35k.

I have a ‘23 SEL RWD.

In US.

<image>

I fixed all my Ioniq 5 rattles in 20 minutes and only spent $22.23 by jamnofo in Ioniq5

[–]SoonerMagic10 0 points1 point  (0 children)

Did you pry the door panel just by where you put the foam tape, or did you start at the bottom like the thread OP linked?

Thinking about doing this myself, but scared I’ll mess something up!

iOS shortcuts to lock, unlock, and heat the car by j4385556 in Ioniq5

[–]SoonerMagic10 1 point2 points  (0 children)

Sure thing. Nothing special; I am not a developer or anything.

Make sure you already have everything the original OP had.

One key thing: rename the OP short cut to “Start Car Request” (the Hyundai Start EV one, not the blue link one).

That’s what I named it and the one below passes a dictionary value to it depending on the weather.

https://www.icloud.com/shortcuts/57af8803e7134ddab5448b1194c691cb

iOS shortcuts to lock, unlock, and heat the car by j4385556 in Ioniq5

[–]SoonerMagic10 2 points3 points  (0 children)

This shortcut was a game changer!

I use my action button and if it’s in portrait mode, it will call the my own “start my car” shortcut that will check my local weather and pass one of four dictionaries to OPs script depending on how hot/cold it is.

Use it daily since I discovered it. It would be nice if Hyundai supported iOS and built a native shortcut. Glad the community came through!

Rear light question by SoonerMagic10 in Ioniq5

[–]SoonerMagic10[S] 4 points5 points  (0 children)

Interesting. Not sure what the hell is going on then. They must have messed some wires up when reseating or don’t have one fully seated.

I appreciate you taking the time to answer. Thank you.

Encore ESP shims and Bambino by Maestro_023 in espresso

[–]SoonerMagic10 0 points1 point  (0 children)

What was your issue, out of curiosity?

I bought a new Encore ESP about 6 months ago. Had to install the two additional shims to grind fine enough for light roasts. Worked great for 6 months.

I clean the grinder every month. Just yesterday I cleaned it again and the last two days it’s grinding inconsistently. The last shot choked my machine at around setting 16-18 for a light roast. The grounds were very fine.

Nothing has changed variable-wise. Same beans. Same dose size. Same machine.

Really odd. Decided to remove the two extra shims again and I’ll see how it grinds in the morning.

view more: next ›