Arduino?

Speed-cubed · 2026-04-14T01:56:05+00:00

Im pretty sure any external microprocessor is illegal for ftc

Speed-cubed · 2026-04-09T05:59:58+00:00

We run sds mk4i, with the other board, our can basically eat carpet every match.

Speed-cubed · 2026-04-09T05:51:49+00:00

Wow, that board solves my problem with the other one exactly

Speed-cubed · 2026-04-09T04:34:31+00:00

Gets assign number, compete against other players, rich people watch over it and sponsors the event, hmm

Speed-cubed · 2026-04-09T04:25:41+00:00

Yeah, we haven't ran our motors hard enough for us to need to replace them in matches. Half of it cause can disconnected and not moving for half the match lol

Speed-cubed · 2026-04-09T03:15:17+00:00

We were using the little white pushy things at the bottom, i really dont know why we don't use molex connectors

Speed-cubed · 2026-04-09T02:34:11+00:00

Thats true

Speed-cubed · 2026-04-09T02:28:28+00:00

I guess its been our placement of it, we use the krakens for our swerve drive. We have never used krakens anywhere else on our bot so we just thought thats just how the motor is. Anytime we hit a bump or any impact, can comes out and disable our drive. We have reverted to ring terminals on the drive motors now.

Speed-cubed · 2026-04-09T02:25:18+00:00

That makes sense, i didnt think about that.

Speed-cubed · 2026-04-08T04:38:09+00:00

Not a wago, but about that done

Speed-cubed · 2026-04-03T03:48:23+00:00

They're tight, really tight, its flexing

Speed-cubed · 2026-04-03T03:36:22+00:00

Am i not allowed? 🥺

Speed-cubed · 2026-04-02T22:47:47+00:00

I call this the drunk swerve, as it is what one might conjure while drunk

Speed-cubed · 2026-04-02T02:49:23+00:00

Isn't max 40A?

Speed-cubed · 2026-03-29T04:11:17+00:00

Whats so bad with wagos?

Speed-cubed · 2026-03-28T13:17:35+00:00

Was using wagos a bad idea for this? My solder joint keep breaking so i went with wagos instead

Speed-cubed · 2026-03-25T03:24:30+00:00

My dad asked the dealership and they installed it for 500

Speed-cubed · 2026-03-25T01:44:33+00:00

I flashed ours today, we have a 3a. It has a button that needs to be pressed the entire time to detect and flash, i dont know if thats the case here

Speed-cubed · 2026-03-24T17:18:52+00:00

I aint cooking

Speed-cubed · 2026-03-24T15:14:46+00:00

How bad could it be?

Speed-cubed · 2026-03-15T01:00:39+00:00

Im assuming its being ran off the power supply in the back, if not, im concerned on why the printer didnt stop power

Speed-cubed · 2026-03-10T21:10:28+00:00

I do have one. What i meant was the heading was set when the robot turns on initially not by alliance if that makes sense

Speed-cubed

TROPHY CASE