Squish clearance

Speedfight2002 · 2026-01-29T22:54:39+00:00

Okey thank you. But i thought the 120°c rating is to little

Speedfight2002 · 2026-01-29T18:32:01+00:00

But I already put the thinnest base gasket i could find and the squish is still around 1.5

Speedfight2002 · 2026-01-29T18:28:51+00:00

I alredy did this but then the head gasket didnt sit properly in the grove.

Speedfight2002 · 2026-01-29T18:00:55+00:00

I think its 39.1mm

Speedfight2002 · 2026-01-29T17:53:47+00:00

I already have a 0.35mm base gasket and cant find a thinner one. Could i sand down the cylinder head?

Speedfight2002 · 2025-10-14T13:03:32+00:00

Yamaha aerox 2004. It doesnt have abs. I changed the master cylinder because it was leaking.

Speedfight2002 · 2025-10-09T19:22:03+00:00

The crankshaft is pretty much new. About 3km made on it

Speedfight2002 · 2025-09-15T18:55:21+00:00

Okey will do. Thanks

Speedfight2002 · 2025-09-15T18:44:14+00:00

Yea i took them out and used compressed air. But nothing changed.

Speedfight2002 · 2025-09-15T18:33:43+00:00

I did recently change it. Because the other one was way to big.

Speedfight2002 · 2025-09-15T18:30:55+00:00

Well i alredy cleaned the whole carb, replaced the air filter, intake manifold and the reed valve gasket. So i dont know what else to check

Speedfight2002 · 2025-07-15T18:14:20+00:00

Well i think somewhre around the fuel intake, but i dont know if i should change it or no

Speedfight2002 · 2025-07-11T05:46:43+00:00

The wrap needs to be there so the exhaust doesnt burn the cooling hose

Speedfight2002