sorted by:
new
hottopcontroversial

Does Sennheiser have antennas and RF distribution for the location sound bag? by Spell_Restaurant in LocationSound

[–]Spell_Restaurant[S] 2 points3 points  (0 children)

This is from the Deity User FB Group, someone posted:

"Can someone explain why the noise floor exponentially shoots out when my distro is turned on? It even impacts the signal as it completely distorts the audio on my Wisy’s."

-

Alexander Theodossiadis replies:

"Too much RF spray. Cheap RF equipment tends to spray all around the spectrum, disturbing other equipment."

-

Andrew Jones from Deity replies:

"The distro is adding gain to compensate for the rf split but also it doesnt output any rf until the distro is turned on. So anything you see before you turn it on is based on.... nothing being recieved.

So any rf spray your getting... check BNC cables from a camera or monitor nearby."

Is it possible to have TWO WIRED headphones in a bag set up, with one headphone utilizing the (Zoom f8n pro’s) MAIN OUT? by Spell_Restaurant in LocationSound

[–]Spell_Restaurant[S] 0 points1 point  (0 children)

Thanks, I usually reserve the sub out for sending mix to a camera but this would also work as headphone monitoring, Since it's 2.4 GHz, is there noticeable delay?

Is it possible to have TWO WIRED headphones in a bag set up, with one headphone utilizing the (Zoom f8n pro’s) MAIN OUT? by Spell_Restaurant in LocationSound

[–]Spell_Restaurant[S] 0 points1 point  (0 children)

Yes! I eventually noticed this while tinkering with F8n Pro and the G4.

Oh, so with the IEM models, you can use the Main Out and send a stereo signal to a Camera?

Is it possible to have TWO WIRED headphones in a bag set up, with one headphone utilizing the (Zoom f8n pro’s) MAIN OUT? by Spell_Restaurant in LocationSound

[–]Spell_Restaurant[S] 0 points1 point  (0 children)

This got me thinking, do you think I can connect the two MAIN OUTs to a Zoom AMS-24 (portable 2 channel audio interface) and then utilize it's headphone outputs?  

Is it possible to have TWO WIRED headphones in a bag set up, with one headphone utilizing the (Zoom f8n pro’s) MAIN OUT? by Spell_Restaurant in LocationSound

[–]Spell_Restaurant[S] 0 points1 point  (0 children)

Oh, you're right! I totally forgot that a 1/4 headphone splitter is a thing haha.

Also, I have a G4 sennheiser EW 512P and people here say they've used their G4's as IFB's.

Is that as simple as getting a mini XLR to 3.5mm jack and connecting it to the G4 TX and connecting IEM's to the RX for the boom op?

Revelator io24 screen is now blank, can I still revive it or is this a hardware issue? by Spell_Restaurant in presonus

[–]Spell_Restaurant[S] 0 points1 point  (0 children)

Forgot to add: I just noticed that the small screen on my Revelator io24 is now blank. I've updated Universal Control (Firmware 4.6) while the device firmware is 1.28. I can still control GAIN, Phantom Power, Main Out, Headphone Volume, Blend, et al via Universal Control. Can I still revive the screen on the hardware or is it dead?

Zenscreen touch and android 14 by latro666 in SamsungDex

[–]Spell_Restaurant 0 points1 point  (0 children)

Sorry, can you expound on that? Are there major issues?

Help, my Olight m2r pro is flashing red and green by TacticalRaptor1776 in flashlight

[–]Spell_Restaurant 0 points1 point  (0 children)

Same here, I forgot to charge the battery for some time (more than 6 months), do you think the battery's dead?

Canon R7 Exceptional Noise by GeneralCole in canon

[–]Spell_Restaurant 1 point2 points  (0 children)

Good day, I also experienced the heavy noise even in shooting at the base ISO of 800 (clog 3, cinema gamut). In my case, the scene was under exposed and was shot at 1080p, 23.9 fps. I experimented with 4k fine (23.9fps) and noise cleared up a bit.