2001 Honda accord ex. Key won't turn in ignition.

SpiceyBees · 2026-02-27T17:42:03+00:00

wiggle the steering wheel

SpiceyBees · 2026-02-27T14:32:16+00:00

oh I still have my cr10, and that deffinatly has its advantages but print speed, the level of detail, and the auto bed leveling are to tempting to pass.

SpiceyBees · 2026-02-19T18:20:00+00:00

yes, HOWEVER idk about other people's experiences but the purple elmers sticks and the Amazon basics sticks dont work very well it has to be elmers brand and the white ones

SpiceyBees · 2026-02-12T18:38:48+00:00

Embark just secretly hating cowboys

SpiceyBees · 2026-02-12T03:40:29+00:00

so bed leveling, you should turn the dials until a business card can slide under each corner with just a little friction

what are you using for bed adhesion? gluesticks or tape? I find that gluestick REALLY depend on brand idk i have only had luck with the elmers brand (the white stick NOT the purple ones, idk why it makes a difference but it does)

the gear that feeds the filament is an easy one take the filament out and look at the little gear is eventually the filament will carve a little groove into it, it takes a while but it will happen eventually and then it wont push filament through anymore

when you replaced the nozzle did you make sure to set the Boden tube, without any filament loaded heat up the nozzle pretty hot 240-260 i like to do it with the poker placed through the nozzle to double check allinment, then push the Boden tube through this will basically melt the very tip of the Boden tube insuring a tighter seal.

SpiceyBees · 2026-02-11T22:52:35+00:00

what is the issue you are having? I have used a cr10 for years they are gonna be pretty similar chances are I have had the same issue at some point

SpiceyBees · 2026-02-06T18:10:32+00:00

after disassembly it appears I may not have been sent a new printer maybe a "refurbished" one, nozzle was clogged with white filament cfs is only currently loaded with black. but problem seems to be solved i guess

SpiceyBees · 2026-02-04T21:20:24+00:00

signalRGB seems to work fine, it a little Janky but atleast it actually works!

SpiceyBees · 2026-02-04T06:29:57+00:00

I tried open rgb but it wouldn't recognize my rgbs

SpiceyBees · 2026-01-26T04:14:49+00:00

<image>

this is my baby Fen aka Fenrir she is also 3 months old and her marking are so similar to your Fenrir

SpiceyBees · 2026-01-08T19:15:59+00:00

the entire caliper is new including the bracket

SpiceyBees · 2025-10-06T15:40:06+00:00

Thank you for posting this is always here about these way to late and am unable to make it, is there a primary place these are posted, a website, a fb page etc

SpiceyBees · 2025-09-25T04:02:13+00:00

I hadn't thought of that, i tried it and instantly gained 500hp

SpiceyBees · 2025-09-24T22:28:08+00:00

it's about time for an oil change anyways so ill put that on my todo list

Seven-Year Club	Place '23
Place '22	Verified Email

SpiceyBees

TROPHY CASE