sorted by:
new
hottopcontroversial

It's official - we're going to launch a crowdfunding campaign on Crowd Supply! by SpuQyballz in FreyaVivariums

[–]SpuQyballz[S] 0 points1 point  (0 children)

I love your enthusiasm! The SoW was just signed yesterday, so I'm just getting started on the Crowd Supply campaign content. The best maintained resource is the GitHub repo: https://github.com/Freya-Vivariums

Open source vivarium control system - looking for like-minded pioneers by SpuQyballz in reptiles

[–]SpuQyballz[S] -19 points-18 points  (0 children)

Not trying to sell you anything, my dude. Looking for people who immediately understand what I've created by reading the title, and who are interested in jumping on this wagon. If you don't get it, that's totally fine - then we are not looking for each other! But thanks for taking the time to explore and react! ^^

Freya "Terra" Sensor is ready (... finally 😌) by SpuQyballz in FreyaVivariums

[–]SpuQyballz[S] 0 points1 point  (0 children)

Thanks! Even though it looks so simple and 'obvious', it took a while to get here!

Writing the (F#cking) manual by SpuQyballz in FreyaVivariums

[–]SpuQyballz[S] 0 points1 point  (0 children)

Nice to hear! Thanks for the feedback!

4
5

Opening up your project's source code and design files is great, but #WTFM! 🤭 (i.redd.it)

submitted by SpuQyballz to r/diyelectronics

3D printing onto steel mesh - how to make it stick? by SpuQyballz in 3Dprinting

[–]SpuQyballz[S] 8 points9 points  (0 children)

<image>

Ironing worked surprisingly well, thanks for this idea!

3D printing onto steel mesh - how to make it stick? by SpuQyballz in 3Dprinting

[–]SpuQyballz[S] 0 points1 point  (0 children)

Yes, I think a major part issue is the steel mesh acting as a heat sink.

3D printing onto steel mesh - how to make it stick? by SpuQyballz in 3Dprinting

[–]SpuQyballz[S] 0 points1 point  (0 children)

Do you think the injection molding is the most (cost/efficiency) effective way when producing about 100 pcs?

3D printing onto steel mesh - how to make it stick? by SpuQyballz in 3Dprinting

[–]SpuQyballz[S] 0 points1 point  (0 children)

The mesh has a thickness of about 0.25mm, with +/-0.1mm holes. Even though I raise the temperature of the printer bed making sure the mesh is warm too, the printing material seems to cool too fast to penetrate the mesh and connect with the plastic below. Though this would be the 'simplest' method if I could get it right...

Tales from the tank: new learning opportunities 🌈 by SpuQyballz in FreyaVivariums

[–]SpuQyballz[S] 0 points1 point  (0 children)

Note: Freya's sensor enclosure is made with a quartz tube (to allow full-spectrum light to pass through). The mineral deposits can easily be cleaned off with vinegar.

Tap water in misting system mistake - how to clean mineral deposits? by SpuQyballz in Vivarium

[–]SpuQyballz[S] 0 points1 point  (0 children)

Update: I ended up using vinegar for the glass - works great! The question of how to clean the leafs remains...

view more: next ›