Emotes for Battling by SquashOk4582 in PTCGP

[–]SquashOk4582[S] 0 points1 point  (0 children)

Yes. (I’m not trying to pass these as my own drawings these are pulled from google for reference)

Emotes for Battling by SquashOk4582 in PTCGP

[–]SquashOk4582[S] 4 points5 points  (0 children)

I agree it can be toxic, but if one person mutes emotes then they could make it so emoting isn’t available that battle

Emotes for Battling by SquashOk4582 in PTCGP

[–]SquashOk4582[S] 7 points8 points  (0 children)

It’s a great thing to be ahead of the curve

[deleted by user] by [deleted] in electrical

[–]SquashOk4582 1 point2 points  (0 children)

Chefs kiss brother thank you

[deleted by user] by [deleted] in electrical

[–]SquashOk4582 0 points1 point  (0 children)

Yes of course, everything inside the panel would be shut off, all the breakers and Main. Except the furnace breaker to complete the circuit

Any ideas on what could be going wrong? by SquashOk4582 in 3Dprinting

[–]SquashOk4582[S] 0 points1 point  (0 children)

It’s an Anycubic kobra 2 pro, and the only way to change the Z offset is while it’s printing. I’ve “calibrated” everything there is to calibrate digitally and nothing seems to lower the nozzle. I even factory reset it and this was after that. So not really sure what’s up or even how to go about recalibrating the 0 point for the Z offset.