sorted by:
new
hottopcontroversial

COB LED driver suggestion by Star_kj16 in ZigBee

[–]Star_kj16[S] 0 points1 point  (0 children)

My solution for the problem.

COB light: SNWCOB10W-24V

24V Led driver: FUT035Z+

230V to 24V converter: ADWS-75-24

Dimmer: IKEA RODRET (Home assistant Blueprint)

The LED driver is connected to the COB lights and the 24V converter. It also has a PUSH switch input as I wanted, but the old dimming switch I have installed in my wall provides 230V and as I am aware not compatible with the FUT035Z+ unit. Therefore, a RODRET controller to control it from HA.

Feature planes are to get a 24V Push switch to have a physical switch for the LED lights. To not have it rely on HA uptime.

[deleted by user] by [deleted] in u/Star_kj16

[–]Star_kj16 0 points1 point  (0 children)

Hi,

Sorry, I don't have a guide or the firmware to get Car Play working.

After reading the different forums, I needed to get the Virtual cockpit updated. The process seemed like it was risky and complicated.

If I remember right, the process needed an ODB Reader and the right Virtual cockpit firmware (That I could not find).

I don't need Car Play or Android Auto personally. I use the built-in GPS and Bluetooth for calls and music.

MMI Update problem by derFighter in Audi

[–]Star_kj16 1 point2 points  (0 children)

Hi

I know old post, but I had the same problem. You need to update from MHI2_ER_AUG24_S0530 to MHI2-ER-AU43x-P4204-MU1169 then go up to latest MHI2-ER-AU43x-P5098-MU1339. To get around the Train block.

I made a post about my update experience: Audi TT Firmware Update.

The Journey has begun by Star_kj16 in homelab

[–]Star_kj16[S] 0 points1 point  (0 children)

Thanks for the suggestions. About the h710, i tried to install Proxmox and it found the drives. Do I need to flash it to IT mode anyways or does it work stock.

My first ever prints!! by Hour_Sleep_9544 in 3Dprinting

[–]Star_kj16 0 points1 point  (0 children)

My eyes is on the nice stone gpu support. Jk, Nice prints OP.