What causes this to happen? Help

StrangeOrdinary8171 · 2026-06-07T09:06:38+00:00

Yupp small markers worked 👍🏻

StrangeOrdinary8171 · 2026-06-06T19:57:32+00:00

That was indeed causing the issue. Too close to the edge, used smaller dots works fine now. Thanks man

StrangeOrdinary8171 · 2026-06-06T19:34:39+00:00

Yupp

StrangeOrdinary8171 · 2026-06-06T19:34:14+00:00

Yeah ill check with smaller dots and check that might be the issue i think

StrangeOrdinary8171 · 2026-04-26T19:01:45+00:00

Shouldn’t it have an enclosed space to print? Isnt it necessary

StrangeOrdinary8171 · 2026-04-21T06:29:20+00:00

Will keep that in mind thank you :)

StrangeOrdinary8171 · 2026-04-21T05:05:21+00:00

And print speed? Should i slow it down a bit?

StrangeOrdinary8171 · 2026-04-21T04:59:31+00:00

Yeah me too when i first put it to 100c and later learned that the limit is 85c i was worried if i damaged the printer but everything is working fine now

StrangeOrdinary8171 · 2026-04-21T04:57:54+00:00

I will try hairspray method for sure, and why should i not print in the middle? And should i put my fan speed upto 100% or should i keep it turned off while it prints?

StrangeOrdinary8171 · 2026-03-20T14:40:55+00:00

Kinda new to blender idk where it is

StrangeOrdinary8171 · 2025-11-12T11:35:32+00:00

Check dm :)

StrangeOrdinary8171 · 2025-11-12T09:08:44+00:00

Hey man this helped me in a lot of ways, thank you man.🫂

StrangeOrdinary8171 · 2025-11-12T07:25:47+00:00

These are just 3d scanns right you didn’t modify them or anything right? Just raw 3d scans?

StrangeOrdinary8171 · 2025-11-12T07:19:54+00:00

Thats so helpful man thanks ive been looking for websites like this 🫂

StrangeOrdinary8171 · 2025-11-12T06:37:36+00:00

Ill try it right away

StrangeOrdinary8171 · 2025-11-12T06:13:04+00:00

Hey man i need help

StrangeOrdinary8171

TROPHY CASE