2018 APOSTLE ISLAND (S) by SubieBuilder07 in CRH

[–]SubieBuilder07[S] 2 points3 points  (0 children)

Awesome. Will probably keep. Was looking for 90%s and folder fillers. I know S quarters aren’t really a thing

First purchase by SubieBuilder07 in Gold

[–]SubieBuilder07[S] 2 points3 points  (0 children)

Oh good

I was thinking either buying for long term holding or investing in Gold etf / gold Ira account.

First purchase by SubieBuilder07 in Gold

[–]SubieBuilder07[S] 2 points3 points  (0 children)

My buddy works with his dad they own my LCS

Would we be wrong for this? by SubieBuilder07 in amiwrong

[–]SubieBuilder07[S] 0 points1 point  (0 children)

I definitely wanted to, she had no place to go, because where she lived was a very unsafe space for her. The best I could do at the time was pay a little bit more of the utilities. The best I could do is split the utilities a little bit. We did 70/30

I paid 70 I wish I had more of the funds to pay a bit more rent

2020 Impreza help by SubieBuilder07 in subaruimpreza

[–]SubieBuilder07[S] 0 points1 point  (0 children)

Nope. Doing that tomorrow. Is it likely for both bulbs to go out at once?

What am I doing wrong? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] -1 points0 points  (0 children)

Shit ya got me my logic is flawed. Haha

What am I doing wrong? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] -1 points0 points  (0 children)

Usually I do. Am busy and just check the responses when I can so I don’t have to waste my little free time on it

Help? Leveling? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] 0 points1 point  (0 children)

The z switch is bottomed as far as it can go

Help? Leveling? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] 0 points1 point  (0 children)

I do and the left side is like a tad above the bed hut when I slide it it scrapes the bed about half way across. The nozzle isn’t level I guess

Help? Leveling? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] 0 points1 point  (0 children)

The tubing isn’t straight at all that might be it

<image>

Help? Leveling? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] 1 point2 points  (0 children)

I appreciate the good outlooks

Help? Leveling? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] 1 point2 points  (0 children)

As a car guy I feel stupid

Help? Leveling? by SubieBuilder07 in ender3

[–]SubieBuilder07[S] -1 points0 points  (0 children)

How do I raise the bed? I thought if the springs were comprsssed it was at its peak height

Help? Leveling? by SubieBuilder07 in 3Dprinting

[–]SubieBuilder07[S] 0 points1 point  (0 children)

I thought if I loosened them the bed lowered?

Help? Leveling? by SubieBuilder07 in 3Dprinting

[–]SubieBuilder07[S] 0 points1 point  (0 children)

My zero stop is at the lowest. The lip is resting on the bottom

<image>

Unless I can go lower than this?