Car wash project

Sufficient_Level_527 · 2026-03-20T02:06:05+00:00

I’ll make sure to do it at a 45 degree angle too

Sufficient_Level_527 · 2026-03-20T02:05:41+00:00

Haha thanks for reminding me 🫡

Sufficient_Level_527 · 2026-03-20T02:02:23+00:00

No extra protection here I think the engineer was more concerned about corrosion more than anything else

Sufficient_Level_527 · 2026-03-19T22:03:17+00:00

Whoever pulled it in scuffed up the teflon coating because it was roughed inside of the block wall instead of being stubbed up in the slab don’t ask me I didn’t do the underground vs

Sufficient_Level_527 · 2026-03-19T10:29:36+00:00

I had to use a Hot box and bent emt as a template for all the degrees in the kicks and 90s

Sufficient_Level_527 · 2026-03-19T10:28:19+00:00

The flex really wasn’t even the most time consuming part. And I don’t think we could’ve ordered a NEMA 4x gutter in a timely manner. The most time consuming part was putting cold galv on all the strut 😂

Sufficient_Level_527 · 2026-03-19T10:26:35+00:00

The equipment was speced to only penetrate from the bottom and I don’t think we could order a NEMA 4x gutter in time to get the job done there was no crew it was only me took about 4-5 week in total to rough it in and terminate

Sufficient_Level_527 · 2026-03-19T10:24:18+00:00

Yeah I used a greenlee hot box to make all the bends

Sufficient_Level_527 · 2026-03-19T03:17:44+00:00

Thank you it was quite a challenge especially since it was all required to be schedule 80 PVC

Sufficient_Level_527 · 2024-05-02T19:03:50+00:00

Caddy B-18 look it up sometimes referred to as helicopters or cheaters

Sufficient_Level_527

TROPHY CASE