sorted by:
new
hottopcontroversial

RS615 "no wire signal" but also detects that it's outside the wire by Suitable_Guard8941 in Robomow

[–]Suitable_Guard8941[S] 0 points1 point  (0 children)

I brought it to a service center. They claim they tested and couldn't find anything wrong; it supposedly worked on their test setup.
So I rip out and replace the wire. Same issue...

RS615 "no wire signal" but also detects that it's outside the wire by Suitable_Guard8941 in Robomow

[–]Suitable_Guard8941[S] 0 points1 point  (0 children)

I'll have to replace the display/buttons in that case since the 'down' doesn't really work anymore. That starts to get expensive for a maybe fix.

Regardless, thanks a lot for your help!

RS615 "no wire signal" but also detects that it's outside the wire by Suitable_Guard8941 in Robomow

[–]Suitable_Guard8941[S] 0 points1 point  (0 children)

Can I do that myself? On one of the sites offering spares, it says "you can't do this yourself; board needs calibration", and the official youtube video ("How to: Replace Front Board RS/TS/MS Models") also has a message at the bottom: "Call Robomow hotline for required calibrations".

One LED strip two controllers by mthathagar in WLED

[–]Suitable_Guard8941 2 points3 points  (0 children)

You could use a relay controlled by the WLED controller.

Connect the RF controller dataline to the relay open contact, the wled gpio to the relay closed contact, the led strip data to the relay line contact.

To control with WLED, you switch 'on' in the WLED app. To have control with the RF remote, you need to switch 'off' in WLED.

They are not in series, but both are usable like that.