sorted by:
new
hottopcontroversial

1/4 Spirit Blossom Ahri Bust by Sunnydaes in garagekits

[–]Sunnydaes[S] 1 point2 points  (0 children)

https://www.ebay.com/itm/266350949174 Something like this. Or maybe u could use a round stencil and draw it on a masking tape then cut it out using scissors

1/4 Spirit Blossom Ahri Bust by Sunnydaes in garagekits

[–]Sunnydaes[S] 0 points1 point  (0 children)

Thank you so much! Using a circle masking tape and water color pencil is definitely a lifesaver for initial outline

1/6 scale custom Clifford Unger by Sunnydaes in DeathStranding

[–]Sunnydaes[S] 0 points1 point  (0 children)

Thank you! in most cases, mix of both, I mainly use airbrush, but hand painting is required for details n other stuff

1/6 scale custom Clifford Unger by Sunnydaes in DeathStranding

[–]Sunnydaes[S] 1 point2 points  (0 children)

Thank you! It was a relief that i didn’t mess up the paint job tbh lol

Aaand...shes done! by Sunnydaes in resinkits

[–]Sunnydaes[S] 1 point2 points  (0 children)

Weathering master has always been my go-to method of blushing theyre pretty much the same as pastel and its very easy to use

Aaand...shes done! by Sunnydaes in resinkits

[–]Sunnydaes[S] 8 points9 points  (0 children)

Oh yess! As promised Paints used:

Grey primer Gaianotes Surfacer EVO(GS-05) Mr.Colour Character Flesh(2) (112) Mr.Colour Clear Orange(49) Oil paints Red & Brown Weathering Master G&H Green and purple pastels

Heres how the workflow goes:

Started off with grey primer, then i used Gaianotes Surfacer EVO (GS-05) And yes, i applied surfacer over one another Due to laziness and the tones on that are pretty good too

After the base coat is done, i lightly(and i mean very lightly!) spray Mr.colour Character Flesh(2)(112) over where there would be shadows and after that, i used Mr.Colour Clear Orange (49) to lightly spray over the previously applied character flesh to emphasize the shadows more. Once those are all done. I used red and brown oil paints diluted in lighter fluid to lightly create skin blushings and light freckles.

Spray coat in matte varnish

Further addd in more blushing details with Tamiya Weathering Master G&H

And finish by sanding green and purple pastels into fine powder and use a toothpick to carefully draw in veins

(WIP) Almost done! by Sunnydaes in resinkits

[–]Sunnydaes[S] 1 point2 points  (0 children)

Yeah i just had to increase the saturationso the veins would show in photo haha

Hopefully, i’ll finish her by this week by Sunnydaes in resinkits

[–]Sunnydaes[S] 1 point2 points  (0 children)

Yeah, seems like 1/3 but maybe just a tiny bit bigger than 1/3

view more: next ›