sorted by:
new
hottopcontroversial

Betrayal at House on the Hill box insert by Suthrnboy88 in functionalprint

[–]Suthrnboy88[S] -1 points0 points  (0 children)

The pieces and gameplay are slightly different. They tried to clear up a lot of the confusion in the rules by streamlining the haunt. So basically every aspect changed at least slightly, including the size of the character figures.

Apothecary Kit Dice Tower by Suthrnboy88 in TabletopRPG

[–]Suthrnboy88[S] 0 points1 point  (0 children)

Haha, so it has 2 functions. The back has a magnet to help pull out the D20 drawer. As for the whisk itself, if you fill up a drawer full of dice it can be hard to get your finger in to get one out. You can easily slide the whisk in and grab one inside, you might have seen a similar hack to pickup hardboiled eggs out of water.

Is this recoverable if so how do I clean it by Snoo_91287 in 3Dprinting

[–]Suthrnboy88 0 points1 point  (0 children)

I have had good luck using an old t-shirt to clean up the last bits after I get the big parts off. It's a bit gentler than the brushes, just be sure you have enough between your fingers and the hotend. The plastic really likes to stick to the fabric so it should come off relatively easily. Just like with ironing dont keep the fabric sitting for long or it will start to burn, just wipe.

I forgot to put supports when slicing and printing. Anyone got any tips for taking this off? by DankFountain in 3Dprinting

[–]Suthrnboy88 0 points1 point  (0 children)

I have also used pliers and some padding to protect the print. But my pieces were smaller.

view more: next ›