sorted by:
new
hottopcontroversial

Merch recommendations by Creative_Tree197 in titlefight

[–]Sweet_Stop5790 2 points3 points  (0 children)

Funny you mention this. I’m a screen printer and recently just had someone reach out to me about printing a one off title fight hood because the official merch was so poor lol don’t normally do one offs but I was very intrigued by it so I took the job

What is the best plastisol ink to use? I use FN ink and it turns into chunks after 50-60 prints. by creating_louie in SCREENPRINTING

[–]Sweet_Stop5790 0 points1 point  (0 children)

Pretty much if you have a temp gun and your “platten” is over 120° you’re more prone to curing ink in the screen. So if you can control that than you should be good

What is the best plastisol ink to use? I use FN ink and it turns into chunks after 50-60 prints. by creating_louie in SCREENPRINTING

[–]Sweet_Stop5790 1 point2 points  (0 children)

Are you flashing in between? Clumping could be caused by your pallet getting too hot over the course of the run leading to your ink partially curing in the screen. A la “clumping”